car stalls when turning left.

V6 Technical/Performance Discussions
Post Reply
User avatar
94mx3precidia
Regular Member
Posts: 574
Joined: May 12th, 2007, 8:00 pm
Location: Thunder Bay, Ontario

car stalls when turning left.

Post by 94mx3precidia »

Every so often when i turn on a hard left my car shuts off. my radio cuts out and my tach drops but when i straighten out everything turns back on. I heard that it was fuel pump related, like the wiring to the fuel pump. I just checked that now and everything looks well connected with no loose wires/grounds. Im puzzed on this, when it comes to electrical stuff i get confussed.

If anyone has any ideas that would be great.
1994 MX-3 GS KLZE, Probinator, Bully stage 1 (probe GT), B&M Short Shifter, 2 1/4" Custom headders back.
User avatar
Mooneggs
Forum Moderator
Posts: 6128
Joined: August 10th, 2005, 10:08 pm
antispam: ~SPAM*SUX~
Location: Hillsboro, OR
Contact:

Re: car stalls when turning left.

Post by Mooneggs »

I had this happen only it was on right turns... it ended up being bad gas... It took about 10 fill ups before it all got out of the system :?

It could be something else since your radio goes out too! maybe it could be your battery connections? or a bad ground?
User avatar
94mx3precidia
Regular Member
Posts: 574
Joined: May 12th, 2007, 8:00 pm
Location: Thunder Bay, Ontario

Re: car stalls when turning left.

Post by 94mx3precidia »

well so far ive cleaned the grounds on my fuel pump, maybe that will do something but i doubt it. It stated to do it shortly after i did my ze swap then i changed my gas tank, it went away for a bit but now its starting again.
1994 MX-3 GS KLZE, Probinator, Bully stage 1 (probe GT), B&M Short Shifter, 2 1/4" Custom headders back.
User avatar
ElectricEnergy
Regular Member
Posts: 489
Joined: August 15th, 2006, 12:37 am
Location: Saskatoon SK, Canada

Re: car stalls when turning left.

Post by ElectricEnergy »

Mine was having a similar problem because I forgot to tighten one of the bolts for a ground. Make sure all your grounds in the engine bay are good.
Image
KL-ZE Swap - OBX SS Headers - 2.5" Exhaust - Falken Azenis Tires - H&R Springs - ZX-2 Struts - CAI - Front & Rear Tower Bar - AWR Motor Mounts - 100hp wet shot (yet to be tested)
Dan [Sac]
Regular Member
Posts: 41
Joined: December 17th, 2007, 10:58 pm

Re: car stalls when turning left.

Post by Dan [Sac] »

We shall call this problem....the Zoolander complex [/dr. evil]
'90 Mazda 323 - V6 KLDE, supercharged, right-hand drive, build log
'93 Ford Probe GT - a few mods... 10.24 @ 139.5 mph [20 psi] - 545 whp, 490 wtq @ 21psi
1997 Ford Probe GTS (Hybrid) - RWD Conversion - Build Thread
User avatar
94mx3precidia
Regular Member
Posts: 574
Joined: May 12th, 2007, 8:00 pm
Location: Thunder Bay, Ontario

Re: car stalls when turning left.

Post by 94mx3precidia »

I cleaned one of the grounds on the sending unit and it hasnt done it since so i think that i solved the problem. a little bit of dielect greese goes a long way.
1994 MX-3 GS KLZE, Probinator, Bully stage 1 (probe GT), B&M Short Shifter, 2 1/4" Custom headders back.
User avatar
Mooneggs
Forum Moderator
Posts: 6128
Joined: August 10th, 2005, 10:08 pm
antispam: ~SPAM*SUX~
Location: Hillsboro, OR
Contact:

Re: car stalls when turning left.

Post by Mooneggs »

my car is cutting out when I turn right again... what the crap!?!? AUGH :crying:
User avatar
Daninski
Supporting Member
Posts: 7055
Joined: June 18th, 2007, 10:51 am
Location: Trenton ON.

Re: car stalls when turning left.

Post by Daninski »

Jeff Gorden says, turning right, what the fu*k? Why :lol: How about battery terminals, those buggers have caused me issues big time. Recheck and redo, follow every lead and clean every ground. Green is not good. :mrgreen:
2004 Subaru WRX Silver, stage 2, minty interior.
2002 Subaru WRX Blue, SOLD (best E test numbers I've ever seen)
94 MX-6. Sold
92 GS KLZE 5 Speed
96 GS 5 speed, KLZE, Sold
95 GS Minty Shape Sold
92 GS Sold
92 GS Parts Car scrapped.
Feedback viewtopic.php?f=37&t=66348" onclick="window.open(this.href);return false;
7477th member.

I know you believe that you understand what you think I said but I'm sure you realize that what you heard is not what I meant.
Post Reply

Return to “V6 Technical/Performance”