do i got em?

fieromx3 · Post by **fieromx3** » May 10th, 2006, 3:39 pm

well i wondered this for some time but didnt look into it. i have wires going from the floor into my seat. do i got heated seats?? if i do where are the switches? i cant find anything. i searched and john(mx3autozam) said there are on the middle console..i dont got anyswitches only the ''cutouts'' for them. if i dont got heated seat what are the wires for?

Post by **Custommx3** » May 10th, 2006, 3:50 pm

Probably for your seatbelt.

fieromx3 · Post by **fieromx3** » May 10th, 2006, 4:02 pm

o maybe like the seatbelt sensor for the dash light?? yea that could be it

that sux lol

Nd4SpdSe · Post by **Nd4SpdSe** » May 10th, 2006, 9:20 pm

Lol, i remember i though the exact same thing when i first found that out.

MX-3 Money · Post by **MX-3 Money** » May 11th, 2006, 5:18 pm

same here...

cjthor · Post by **cjthor** » May 11th, 2006, 8:11 pm

ejection seat wiring...DONT MESS WITH IT!!!

fieromx3 · Post by **fieromx3** » May 11th, 2006, 8:16 pm

ok lol thats good to know! thx!

BSinnest · Post by **BSinnest** » May 12th, 2006, 9:49 pm

hey, i got ahold of the wires for the heated seats... but i think it is going to be a little more difficult than expected. Even went into mazda, and they couldn't dig up anything for diagrams and such for the wiring of the heated seats.....

So as soon as i get my car going again, going to start tearing out the carpet and dash so i can follow that damned wire...

Going to be a big job to change. may have to remove all trunk interior and re-wire the whole iside again...

I'll keep you guys informed of how it goes!

Brian

Urbanconcept · Post by **Urbanconcept** » May 16th, 2006, 8:45 pm

I've changed my seats a few times and the wire underneath is definately for the seat belt. If you leave it unplugged it doenst make that annoying beeping noise that reminds you to put on your seat belt (I never plugged it back in because I dont need to be reminded to buckle up lol.)

Nd4SpdSe · Post by **Nd4SpdSe** » May 17th, 2006, 2:24 am

i've always wanted to use that wire/switch as a anti-theft, like for the fuel-pump or the ignition. I'm sure theives don't remember to put on their seatbelts before they try to start the car

PatMX3 · Post by **PatMX3** » May 29th, 2006, 10:49 pm

Hey, if you want your comfy seat to be WARM* in the winter time, as i suppose u want, Just by a remote starter,warm up your car for a few mins b4 you r ready to leave* VOILA!!! dont chase the heated seats conspiracy any further! lol

FlyVFR · Post by **FlyVFR** » May 30th, 2006, 12:41 am

cjthor wrote:ejection seat wiring...DONT MESS WITH IT!!!

LMAO

jschrauwen · Post by **jschrauwen** » May 30th, 2006, 1:16 pm

FlyVFR wrote:
cjthor wrote:ejection seat wiring...DONT MESS WITH IT!!!
LMAO

Gotta luv it...LOL.
Wiring for the heated seats?? ==> Going to have to track down a shop manual for the 93 SE version that will include the Canadian section for the wiring of that. Usually the North American manuals cover the variations between the US and Canada wrt electrial/wiring...DRL's - Daytime Running Lights, etc. Alternate possibility would be to go to Grants site and see what's available for a 93 also.

Nd4SpdSe · Post by **Nd4SpdSe** » June 1st, 2006, 9:14 pm

Actually, I'm not 100% sure, but overseas, I believe it was an option (part of the Eunos line) and not just a limited run. You may find it in their generic diagrams as part of the standard wiring for them.

MX-3.com

do i got em?

do i got em?

Heatd Seats*