Having the well documented Dizzy problem with my car again(happens on average every 6 months).
Getting a bit p*ssed off with it now and looking to fit the KLZE ignition system to my car.
I'd follow Gro suggestions with his aftermarket kit but I'm not sure where to lay hands on the parts in the UK.
It would seem to be easier to source the new parts for the KLZE ignition system over here.
My only problem is that I need a KLZE wiring diagram to allow me to match up the wire locations.
Does anybody on the forum have a diagram, if so please PM me.
Thanks in advance for any help
KLZE Wiring Diagram
KLZE Wiring Diagram
1994 MX-3 ZE
- jschrauwen
- Forum Moderator
- Posts: 6052
- Joined: September 27th, 2003, 2:01 am
- Location: Frankford, Ontario, Canada
- Contact:
- jschrauwen
- Forum Moderator
- Posts: 6052
- Joined: September 27th, 2003, 2:01 am
- Location: Frankford, Ontario, Canada
- Contact:
Here you go, it's in my original thread that I updated the other day, added at the end. Cheers.mmac wrote:John
Can you post the links to shop manual & diagrams on ebay
Thanks
http://www.mx-3.com/phpbb2/viewtopic.php?t=46099
'92 GS-ZE - sold, '95 GS - sold, '02 Protege LX - Daughter, '00 Audi A4 2.8 QTip, Ducati TT2
90 JDM RHD 300ZX TT - 572.1 RWHP | 590.0 RWTQ | 21 PSI | Pump gas
90 JDM RHD 300ZX TT - 572.1 RWHP | 590.0 RWTQ | 21 PSI | Pump gas
- babyblueMX3
- Supporting Member
- Posts: 3755
- Joined: February 23rd, 2003, 2:01 am
- Location: Gatineau,Quebec,Canada
- Contact:
I posted a diagram on how to hook up the klze disty with all the other components like couple of months ago
RIP 400whp ZE-T MX-3
Current car : Golf 01 GTI 1.8T (15 psi)
Current car : Golf 01 GTI 1.8T (15 psi)
Thanks Steve
I saw your post with the picture for hooking up the KLZE disty with MSD and external coil.
What I'm looking to do is get all the standard KLZE ignition components and rewire my loom to hook directly up to it. I know I need the KLZE disty and the KLZE external coil, but I don't know if there are any other components in the system and how the wires match up(other than the four going to the disty illustrated in your diagram).
I saw your post with the picture for hooking up the KLZE disty with MSD and external coil.
What I'm looking to do is get all the standard KLZE ignition components and rewire my loom to hook directly up to it. I know I need the KLZE disty and the KLZE external coil, but I don't know if there are any other components in the system and how the wires match up(other than the four going to the disty illustrated in your diagram).
1994 MX-3 ZE