Guage Pod RHD / J-Spec Fog Light Switch

jschrauwen · Post by **jschrauwen** » July 27th, 2005, 6:28 pm

Has anyone found a source in the UK for the Right Hand Drive A-Pillar guage pod(s) that's made for the MX and not just a general purpose stubby one. IE, it will completely replace the old A-Pillar. Thanks;

edit 20/08/05
Still looking and like to add that I need to find the E-Spec/J-Spec fog light switch and pigtail for the dash. I finally found a J-Spec bumper complete with fogs but I would like to keep everything MX or at least Mazda in the interior. If you venture to the junkyard perhaps you could add this to your list, many thanks
John

mmac · Post by **mmac** » July 28th, 2005, 3:01 am

No Not seen anything like that for the MX-3 over here. Accessories & add-ons specific to the MX-3 are pretty thin on the ground over here.

Could you mount the gauges in the blank panel underneath the stereo ?

jschrauwen · Post by **jschrauwen** » July 31st, 2005, 8:06 pm

mmac wrote:No Not seen anything like that for the MX-3 over here. Accessories & add-ons specific to the MX-3 are pretty thin on the ground over here.
Could you mount the gauges in the blank panel underneath the stereo ?

Thanks mmac for that. I was looking to balance my future intrument install by duplicating the complete drivers side a-pillar pod from the NA spec model with the the same from the drivers side of an E-Spec/J-Spec/AU-Spec MX.

jschrauwen · Post by **jschrauwen** » August 20th, 2005, 3:39 pm

initial post editted