This forum is for discussion of topics relating to MX-3 lighting such as Headlights, Tail lights, Accessory Lights, Interior Lights, Etc. For example, Rear Euro Altezza Style Tail lights, Headlight units, LED's, HID's, Bulbs, Interior lights, Neons, Strobes, Auxillary Lights/Fogs or anything filament and gas discharge related.
Also anything dealing with the elctrical system.
dude just follow the instructions will take about 3 hours to do properly.
i've fitted quite a few kits and the mx is the easiest car i've done so far.
one main tip make sure the connections are inulated correctly. and have a lot of tie wraps to hand. Attach the wires to whatever you can to hide them away from damage.
also don't let the wires get too close to your zaust!
Its pretty easy to install..only thing is that you have to find the right place to put the tube. in the front. with a stock bumper, the only place i put it was ziptied to the hatch support thing...and when i put it there, it broke(cuz of the stress) so i had to buy a small 15" walmart tube and that worked GREAT..just set the switch to always on, instead of pulse..and tape it.
all in all..it was pretty easy...AND make sure you put the side tubes behind the jack support..set them after the notch.
in the end...it looks bad a$$.
93 MAZDA MX-3 GS
-1.8L V6
-Underbody Neon Kit (soon to be white)
-Altezzas
-Indiglo gauges (blue)
-DRIFT KIT
-Blue NX racing seats......covers....
Pics here http://members.cardomain.com/vandal_z3ro
i don't know if these pics will be 100% clear but i tried:
front neon:
i hid the back one up into the origional bumper so the tube cannot be seen:
<img src="http://images.cardomain.com/member_imag ... 460_70.jpg" alt=" - " />
I hope this gives some idea for you all.
If people want me to creat a guide on fitting these i can get the car up on ramps wash it down then take some better photo's