parts car

A Forum For Ontario MX-3 Club Related Topics.
Post Reply
User avatar
David Witherow
Regular Member
Posts: 847
Joined: February 1st, 2001, 2:01 am
Location: Brampton/London Ont
Contact:

parts car

Post by David Witherow »

hey if anyone needs anything from a '92 RS i have a blaze red one that was hit in the front end...so hood, rad and headlights are no good...
Tempus
Regular Member
Posts: 273
Joined: May 20th, 2002, 2:01 am
Location: Maltby Washington

Re: parts car

Post by Tempus »

OK here's a strange request for you.... the plastic piece from the fuel door release lever (on floor, to left of drivers seat..)

I'be got just the bare metal, and would love to have the proper 'cover' for that little lever back..
{sigh} Time to move on
Out with the old: Tropical Emerald MX-3 GSR (KL-DE)
In with the new: Phantom Blue Mazda3s GT
fLiP_mAzDa_MX-3
Regular Member
Posts: 70
Joined: June 18th, 2002, 2:01 am
Location: mississauga, ontario
Contact:

Re: parts car

Post by fLiP_mAzDa_MX-3 »

how bout the signal light lenses are they okie if they do how much for it let me know ASAP...thnx
User avatar
Typhoonk
Regular Member
Posts: 1138
Joined: December 31st, 2002, 2:01 am
Location: Bowmanville
Contact:

Re: parts car

Post by Typhoonk »

Hey;

I am looking for the handle on the drivers door. It's black plastic ( the interior handle).

Also I would take the intake tube on the engine. The part from the throttle body to the VAF. Also the two little tubes that go to the crankcase and the idle control.

Heres a long shot. Do you have the RS spoiler on it?

is $45 (canadian) ok for the tubes and handle?

let me know. I'm just out in oshawa, so shipping wouldn't be that much. :driver:
-------------------------------------------------------
Got to sell one of my cars to cover the bills
2002 Mazda Protege 5 - Manual, Blue colour fully loaded
PM for info
User avatar
mazdubber
Regular Member
Posts: 747
Joined: December 12th, 2003, 2:01 am
Location: Cambridge, ON

Re: parts car

Post by mazdubber »

what color is the interior?
92 GS
'Stock'... :twisted:
Phantom4
Junior Member
Posts: 24
Joined: June 4th, 2004, 2:01 am
Location: Stratford Ontario

Re: parts car

Post by Phantom4 »

Do you know if the interior in a 92 is the same as a 95.
MARCUS
User avatar
Nd4SpdSe
Senior Member
Posts: 11212
Joined: May 25th, 2002, 2:01 am
Location: Québec City, Quebec, Canada
Contact:

Re: parts car

Post by Nd4SpdSe »

there is an interior style change between the 92-93 models and the 94+, but its not drastic, if i remember right, the dash/console and the front and read seats are what changed
1992 Mazda Mx-3 GSR - 2.5L KLZE : Award Winning Show Car & Race Car ['02-'09] (Retired)
2004 Mazda RX-8 GT - Renesis Wankel : LS3 Coils, BHR Mid-Pipe + Falken RT-615K 245/40r18
2011 Mazda Mazda2 GS - 1.5L Manual : Yozora Edition (1 of 500)
2003 Nissan Xterra SE - 4x4 Supercharged : 2" Body Lift, 4" Suspension Lift & 33" MTR Kevlar
2001 Nissan Frontier SE - The Frontrailer : Expedition/Off-Road Trailer Project
Phantom4
Junior Member
Posts: 24
Joined: June 4th, 2004, 2:01 am
Location: Stratford Ontario

Re: parts car

Post by Phantom4 »

I am looking for both door lock cylinders and a trunk lock cylinder but I don't need the ignition.
Can this be done?
MARCUS
User avatar
David Witherow
Regular Member
Posts: 847
Joined: February 1st, 2001, 2:01 am
Location: Brampton/London Ont
Contact:

Re: parts car

Post by David Witherow »

tempus i do have that piece how much do you want to give me for it...and its small enough i can just mail it to you...

flip_mazda i have the signals make me an offer..

typhoonk i have the door handle and im pretty sure i have the intake tubes $45 sounds good....when you say RS spoiler do you mean the black plastic piece (or hatch garnish) cause i do have that make an offer....

masdubber the interior is beige

<small>[ August 02, 2004, 07:54 PM: Message edited by: David Witherow ]</small>
User avatar
Nd4SpdSe
Senior Member
Posts: 11212
Joined: May 25th, 2002, 2:01 am
Location: Québec City, Quebec, Canada
Contact:

Re: parts car

Post by Nd4SpdSe »

hows the driver side fender?
1992 Mazda Mx-3 GSR - 2.5L KLZE : Award Winning Show Car & Race Car ['02-'09] (Retired)
2004 Mazda RX-8 GT - Renesis Wankel : LS3 Coils, BHR Mid-Pipe + Falken RT-615K 245/40r18
2011 Mazda Mazda2 GS - 1.5L Manual : Yozora Edition (1 of 500)
2003 Nissan Xterra SE - 4x4 Supercharged : 2" Body Lift, 4" Suspension Lift & 33" MTR Kevlar
2001 Nissan Frontier SE - The Frontrailer : Expedition/Off-Road Trailer Project
Tempus
Regular Member
Posts: 273
Joined: May 20th, 2002, 2:01 am
Location: Maltby Washington

Re: parts car

Post by Tempus »

does $5 seem fair for that plastic lever cover?
{sigh} Time to move on
Out with the old: Tropical Emerald MX-3 GSR (KL-DE)
In with the new: Phantom Blue Mazda3s GT
User avatar
David Witherow
Regular Member
Posts: 847
Joined: February 1st, 2001, 2:01 am
Location: Brampton/London Ont
Contact:

Re: parts car

Post by David Witherow »

sure $5 is fine...

i think the drivers side fender is screwed
Tempus
Regular Member
Posts: 273
Joined: May 20th, 2002, 2:01 am
Location: Maltby Washington

Re: parts car

Post by Tempus »

Great.. you've got a PM.. ;)
{sigh} Time to move on
Out with the old: Tropical Emerald MX-3 GSR (KL-DE)
In with the new: Phantom Blue Mazda3s GT
Post Reply

Return to “Ontario MX-3 Club”