Good idea or not?

MazdaGirl · Post by **MazdaGirl** » June 13th, 2002, 1:02 pm

I have the Apex lowering springs in my 1994 MX-3 and I was wondering if it would be smart to chop some coils out. (The car still sits too high in the back and it looks ridiculous) Has anyone done this before? Is it a good idea or no?

Shadow_Mx-3 · Post by **Shadow_Mx-3** » June 13th, 2002, 1:06 pm

Never done it.Heard it's not a good idea to do that.Security reasons.

Sonicxtacy02 · Post by **Sonicxtacy02** » June 13th, 2002, 1:29 pm

people have done it, i've read in other posts about it. However i wouldnt recommend it. I would be worried about the structural integrity of the springs over time. If you wanna go lower sell your apex's for another brand, thats what i would do.

MazdaGirl · Post by **MazdaGirl** » June 17th, 2002, 1:28 pm

Thanx for the input, I appreciate it.

Post by **Custommx3** » June 17th, 2002, 2:58 pm

I would say NO!!! Ive heard horror stories of a cut spring popping off the strut and busting a tire and other damage.

Andrew_Pakula · Post by **Andrew_Pakula** » June 17th, 2002, 5:03 pm

You are right about the Apex springs sitting a little higher on the rear. I don't like it but it doesn't bother me too much.I have also heard a lot of bad stories from people who have tried what you are suggesting. I don't think I would ever attempt it, it's not worth the risk.

ProtegeSTS · Post by **ProtegeSTS** » June 17th, 2002, 6:38 pm

Umm, "a couple of coils" is NOT good. If you *must* cut them, cut off a 1/4 of a coil at a time and try it. You'd be surprised how much it will lower the car. However, you're already going to be having suspension travel problems, so i would say no to ANY form of lowering more than the springs. The MX-3, unless using VERY STIFF springs, and aftermarket struts does not see any benefit from lowering over 1.5".

MazdaGirl · Post by **MazdaGirl** » June 18th, 2002, 1:57 am

Well, reading the reply's I've received on this topic, I am seriously re-considering the alteration. I have an appointment at the shop on Thursday, which I just might cancel!Thanks so much for the input/suggestions!

MazdaGirl · Post by **MazdaGirl** » June 19th, 2002, 2:38 am

Jeff, thank you very much for this reply. I appreciate you for having them banned. It's nice to know that you care about the "real posters" on this site and that you dont care much for the losers who post stupidity.Thanx again!

monty73741 · Post by **monty73741** » June 19th, 2002, 11:22 am

i think i have an answer for your suspension problems........ get some coilovers.. 399 but they will be adjustable in the rear and frontjason

Tman · Post by **Tman** » July 27th, 2002, 7:21 pm

you can sell my your springs, if you are thinking about buying new ones...or coilovers. Just email me and let me know if you want to sell them.

white fish · Post by **white fish** » July 28th, 2002, 2:22 am

what about cutting a couple inches off the factor spring just to drop it half an inch where would you cut from the top or the bottom

MX-3.com

Good idea or not?

Good idea or not?

Re: Good idea or not?

Re: Good idea or not?

Re: Good idea or not?

Re: Good idea or not?

Re: Good idea or not?

Re: Good idea or not?

Re: Good idea or not?

Re: Good idea or not?

Re: Good idea or not?

Re: Good idea or not?

Re: Good idea or not?