Front stabalizer links replacing ("clunk")
Front stabalizer links replacing ("clunk")
The front stabalizer links have been recalled and they tend to break very easily ant the links and bushings need to be replaced. Mine just went and after changing the cv's, ball joints, struts, and bearings I found out that the loud "clunk"is the stabalizer that has been shifted over. I'm now broke and still need to replace the links. Since theyve been recalled, does that mean that Mazda will replace them for free? If not, how much will it cost?
hi
-
- Regular Member
- Posts: 496
- Joined: November 9th, 2003, 2:01 am
- Location: Calgary, Alberta
- Contact:
Re: Front stabalizer links replacing ("clunk")
Good question dude.
I went in for a multi-point inspection, and they told me all my links were busted and want to charge me $473.08 for them.
It only sounded like my passenger side rear was clunking. Especially notice this in the winter when everything is so damn cold.
I went in for a multi-point inspection, and they told me all my links were busted and want to charge me $473.08 for them.
It only sounded like my passenger side rear was clunking. Especially notice this in the winter when everything is so damn cold.
-
- Regular Member
- Posts: 310
- Joined: February 14th, 2003, 2:01 am
- Location: berwick .maine
Re: Front stabalizer links replacing ("clunk")
the sway bar end links only cost me 85$ usa for both easy job to change them out took me about 45 min to do both
Re: Front stabalizer links replacing ("clunk")
sounds like the problem im having but A.S. does it affect your steering at all or what exactly does the car do other than (clunk)?
Sacramento Raceway, CA
92 Mx3 GS
New Time 13.82 at 101.75 2.205 60ft (RIP beast klze engine)
Updated mods now... KFZE, SS Autochrome Headers and a Sweet a-- 3' Electric Cutout after it, KFZE LSD trans, Millenia manifold, KL36 ecu, Blown motor mounts, custom CAI, Custom ground wire kit, 9mm Plug wires, 2 1/4 exhaust, (Hei and MSD external coil mod), all accessories.
92 Mx3 GS
New Time 13.82 at 101.75 2.205 60ft (RIP beast klze engine)
Updated mods now... KFZE, SS Autochrome Headers and a Sweet a-- 3' Electric Cutout after it, KFZE LSD trans, Millenia manifold, KL36 ecu, Blown motor mounts, custom CAI, Custom ground wire kit, 9mm Plug wires, 2 1/4 exhaust, (Hei and MSD external coil mod), all accessories.
-
- Regular Member
- Posts: 84
- Joined: April 16th, 2003, 2:01 am
- Location: Philly Area, PA
Re: Front stabalizer links replacing ("clunk")
tonguefreek
where'd you get the end links at. I'm planning on replacing mine in the spring but haven't yet looked into where to get the parts.
thanks
where'd you get the end links at. I'm planning on replacing mine in the spring but haven't yet looked into where to get the parts.
thanks
Re: Front stabalizer links replacing ("clunk")
I beleive there is an upgraded bar link that was avalable from Mazda for a while. The cost difference between old and new is small. Have not heard of any recalls though. Try Mazda Competition for bar links.
-
- Regular Member
- Posts: 310
- Joined: February 14th, 2003, 2:01 am
- Location: berwick .maine
Re: Front stabalizer links replacing ("clunk")
i got my bar ends from my local dealership