!!!!Need SMOG HELP!!!!

V6 Technical/Performance Discussions
Post Reply
heavenzjai
Regular Member
Posts: 94
Joined: September 20th, 2001, 2:01 am
Location: sacramento, ca

!!!!Need SMOG HELP!!!!

Post by heavenzjai »

I have a 92' MX3 v6 1.8 and i cant pass the CA smog check. My car is doing a federal smog test, not a CA one (becuase its a non-CA car).

I've failed 3 times so far, and i keep failing on:
Ignition Timing, HC at the 15 and 25 mph, NO at 15mph.

HC
Max ave meas
15 124 31 221
25 98 20 127

NO
15 815 237 1259

I tried using the "guarentee to pass" stuff from Pep boys and what not, and still a no go.however it did help reduce my NO readings.

What should I do??????
916 Blk MX3 V6
rebel2k4
Regular Member
Posts: 542
Joined: February 29th, 2004, 2:01 am
Location: Loveland, CO

Re: !!!!Need SMOG HELP!!!!

Post by rebel2k4 »

Sounds like you may have some bad sensors. Start off by checking your ECU for stored codes (procedure in the V6 FAQ)
94 Mazda MX3 GS - 395 whp 397 ft lbs untuned on pump gas and stock KLDE 15 psi boost. now running 16 psi and E85.. numbers=? 425ish whp
04 GSXR 600- full exh, power commander 3, int turn signals, etc
98 Ford Ranger 3.0L
01 YZ250- most fun vehicle Ive ever owned.
95 Eclipse- built 420a, 60-1, megasquirt, 371 whp @ 17 psi, dsm-broken-car-curse
User avatar
MX3-Freak
Regular Member
Posts: 955
Joined: November 8th, 2003, 2:01 am
Location: Gig Harbor Washington
Contact:

Re: !!!!Need SMOG HELP!!!!

Post by MX3-Freak »

Have you messed with your cat, or the air/fuel mixture? Also, chek your O2 sensor.

<small>[ June 05, 2004, 06:46 PM: Message edited by: MX3-Freak ]</small>
Stock 1995 RS - Creek Blue
Car Meanins:
Honda: Hang On, Not Done Accelerating
FORD: Frequently Overhauled, Rarely Driven
Mazda: Must Always Zoom Down Asphalt
perhapsadingo8yerbaby
Regular Member
Posts: 764
Joined: June 16th, 2002, 2:01 am

Re: !!!!Need SMOG HELP!!!!

Post by perhapsadingo8yerbaby »

Basic question since ya don't mention it, have you done a standard engine tune up before any of those tests?
heavenzjai
Regular Member
Posts: 94
Joined: September 20th, 2001, 2:01 am
Location: sacramento, ca

Re: !!!!Need SMOG HELP!!!!

Post by heavenzjai »

I did change my oil, cleaned my air filter, pulled my intake manifold and cleaned it, used "gurantee to pass", checked for error codes (none).

The only thing different from stock is the air filter. I had better results using a after market filter than the stock air box. The exhaust system is complete stock, which I never touched.

anything else i should do??
916 Blk MX3 V6
perhapsadingo8yerbaby
Regular Member
Posts: 764
Joined: June 16th, 2002, 2:01 am

Re: !!!!Need SMOG HELP!!!!

Post by perhapsadingo8yerbaby »

Ya might try GTA fuel enhancer. You can check it out thru this link http://www.apdinc.com/GTAfuel.html Guy who sells it lives in my town & I've been using all of his products for two years. GTA won't harm your engine, backed by plenty of testing and I've had friends use it to get past emmissions testing with excellent results. It was originally developed to reduce the flammability of jet fuel. The inventor discovered that in internal combustion engines, it also provides for a much more complete burn of the air/fuel mixture by reducing/eliminating the "wetting action" of the fuel mix on cylinder walls. One result is drastically reduced emmissions byproducts. Amazing stuff. I started using it after advancing my timing which then required premium grade higher octane fuel. With the GTA, I use regular grade gas & it only takes two ounces of GTA per tank. But, ck. the link out, do the reading and you be the judge.

<small>[ June 07, 2004, 06:18 PM: Message edited by: perhapsadingo8yerbaby ]</small>
lazzyie
Regular Member
Posts: 1094
Joined: May 24th, 2002, 2:01 am
Location: Fing Boise Idaho Hell!

Re: !!!!Need SMOG HELP!!!!

Post by lazzyie »

Damn that is worse than my ze did you should check your timing needs to be set correctly. Change to lower octane gas and the car will automatically not advance the timing as far.
93 Mx-3 GS klze swapped(sold)
96 Integra LS DD
91 Crx Si drag car
2.0L sleeved gsr block, forged internals, skunk2 valvetrain, HP racing intake manifold, Holset H1 turbo, 1000cc injectors, short geared lsd transmission, 3" turboback exhaust. 20 psi :)
heavenzjai
Regular Member
Posts: 94
Joined: September 20th, 2001, 2:01 am
Location: sacramento, ca

Re: !!!!Need SMOG HELP!!!!

Post by heavenzjai »

come on guys, I need help here!!!
916 Blk MX3 V6
User avatar
jpwmx3
Regular Member
Posts: 364
Joined: August 8th, 2002, 2:01 am
Location: Waterloo, Canada
Contact:

Re: !!!!Need SMOG HELP!!!!

Post by jpwmx3 »

You said "The exhaust system is complete stock, which I never touched."
I would check your CAT. It's probably not doing its job.
User avatar
mazdubber
Regular Member
Posts: 747
Joined: December 12th, 2003, 2:01 am
Location: Cambridge, ON

Re: !!!!Need SMOG HELP!!!!

Post by mazdubber »

Originally posted by jpwmx3:
You said "The exhaust system is complete stock, which I never touched."
I would check your CAT. It's probably not doing its job.
Agreed. You be amazed with what a new cat can do.
92 GS
'Stock'... :twisted:
User avatar
MX3-Freak
Regular Member
Posts: 955
Joined: November 8th, 2003, 2:01 am
Location: Gig Harbor Washington
Contact:

Re: !!!!Need SMOG HELP!!!!

Post by MX3-Freak »

Did you check/replace your O2 sensor when cleaning your manifold? This could alos be the problem...
Stock 1995 RS - Creek Blue
Car Meanins:
Honda: Hang On, Not Done Accelerating
FORD: Frequently Overhauled, Rarely Driven
Mazda: Must Always Zoom Down Asphalt
Post Reply

Return to “V6 Technical/Performance”