engine question...
-
- Junior Member
- Posts: 6
- Joined: July 2nd, 2003, 2:01 am
- Location: Waxahachie, Tx
engine question...
i read things about those rotary engines, could those actually be put in an mx-3 or is it just not possible?
Re: engine question...
Possible, yes, will anyone do it, nope. It was done in a drag car but there was nothing mx-3 left in it besides the look a like body.
-
- Regular Member
- Posts: 1074
- Joined: July 30th, 2003, 2:01 am
- Location: Cape Cod, MA
- Contact:
Re: engine question...
The biggest problem is there are no front wheel drive mazda rotary transmissions. If you wanted to convert your car to rear drive then the rotary engine swap would be the easy part :p
93 MX-3 GS- ZE, KL31 ECU, Fidanza Flywheel, CM Stage 2-R clutch, Hotshot Headers
99 Subaru Impreza RS, the new toy
91 Eagle Talon Tsi AWD *RIP*
99 Subaru Impreza RS, the new toy
91 Eagle Talon Tsi AWD *RIP*
-
- Forum Moderator
- Posts: 3415
- Joined: September 3rd, 2002, 2:01 am
- Location: Eastern Hemisphere
- Contact:
Re: engine question...
swapping to rotory your talking about around 30k for everything hell it would be cheaper to have an rx7 cut to where the mx3 body would fit over it
08 Infiniti G37s 6speed (The Daily)
Stillen Cold Air Intake, Z1 Plenum Power Mod, Z1 Headers, Z1 Test Pipe, OBX (Ark) Exhaust, Up-Rev Osiris Engine Management (Tuned at Z1), 20x9" 20x10" Str Racing Concave Staggered Rims, SPC Camber kit, Tein H Techs Springs
01 Lexus Is300 (LS2 Project)
93 Mx3 SE 2.5 KLZE (sold it)
93 Mx3 GS 2.0 KFZE (killed it)
Stillen Cold Air Intake, Z1 Plenum Power Mod, Z1 Headers, Z1 Test Pipe, OBX (Ark) Exhaust, Up-Rev Osiris Engine Management (Tuned at Z1), 20x9" 20x10" Str Racing Concave Staggered Rims, SPC Camber kit, Tein H Techs Springs
01 Lexus Is300 (LS2 Project)
93 Mx3 SE 2.5 KLZE (sold it)
93 Mx3 GS 2.0 KFZE (killed it)