David's Porting Job
-
- Senior Member
- Posts: 2516
- Joined: November 7th, 2000, 2:01 am
- Location: Gainesville, FL USA
- Contact:
David's Porting Job
I never see pics of anybody's port work, so I figured I'd be the first to post pics and specs of my job. I dont care if you copy me cause I didnt do anything special <P>The red area is where I put the gasket over the runners and colored it with sharpie. Ported with a rotary carbide bit on a 14 volt dewalt till the red was gone. About 0.3" wider, 0.125" taller, and tapered down to stock size 2" down as measured by my dial calipers. $6 well spent. <BR>1) <BR>2) <BR>3) <BR>4) <BR>5) <BR>6) <P><BR>Any questions or comments?<P><P>------------------<BR>David Coleman- <B><I>Moderator</B></I><BR><A HREF="http://www.PinkMX-3.com" TARGET=_blank>1993 Mazda MX-3 GS Special Edition</A><BR><B><I>Why get clear tail lights when only Geo Metros are gonna see them?</I></B>
David Coleman
I used to know alot about MX-3's, but not so much anymore. Oh well.
I used to know alot about MX-3's, but not so much anymore. Oh well.
-
- Senior Member
- Posts: 2516
- Joined: November 7th, 2000, 2:01 am
- Location: Gainesville, FL USA
- Contact:
Re: David's Porting Job
7) <BR>8) <BR>9) <P>------------------<BR>David Coleman- <B><I>Moderator</B></I><BR><A HREF="http://www.PinkMX-3.com" TARGET=_blank>1993 Mazda MX-3 GS Special Edition</A><BR><B><I>Why get clear tail lights when only Geo Metros are gonna see them?</I></B>
David Coleman
I used to know alot about MX-3's, but not so much anymore. Oh well.
I used to know alot about MX-3's, but not so much anymore. Oh well.
Re: David's Porting Job
what this mod do to your engine ?? or car ?<BR>thanks in advance