MX-3.com

i had the same problem. I used my compressor , put it on full pressure, disconnected my thermostat, took like a air chuck and blew into the input and output of the lines going into the heatercore. i gots heat baby. of course it only worked for a while. i gots to do it agains to flush it once more ...

Been there done that.
DO NOT WASTE OUR MONEY.
if u want a kool spiral spinning noise then buy it and put it in ur exhaust pipe. kinda sounds kool cuz it sounds like a turbo but u know. not work $70.

I did replace my gas cap a while ago. I had lost the OEM one and i purchased another one designated for the x-3. The cap seems to fit on there pretty tight though too.

Forgot to mention that i did remove the resonator. I am also wondering if that could cause it to smell like fuel all the time. Other than that there are no leaks or anything like that that i can notice, physically inspecting it.

That is what is funny though, i don't see any leaks on the ground even if i let it run for a while. I am just wondering if it is coming from my engine bay.

My Vehicle seems to smell like gas once it has been running and it comes to park. I dunno if my fuel lines are leaking or what. Any suggestion as to what might be going would be appreciated.
thanks.

thanks
i do have an autozone, i think that i go that route
thanks again for the input

Is there a way to install or uninstall the inner tie rod w/o the special tool.
I would take it to the shop but i dun want to have to pay an arm and a leg for the install of the inner tie rod. Also most shops will not install carry in parts.
If anyone has any ideas it would be much appreciated ...

dang, u guys get good gas milage. my gs get like 25-27 hwy and like 23 for city. must be something wrong with my gs. i gots an intake and opened up exhaust though.
aniwaise peace out.

thanks for the info. I thought about doing a ze swap and going all motor. I am also interested in the bpt swap but the electronics i think woud be a headache. i do know that our tranny and everything else bolts up but the ecu wiring would be the headache.
Alrite i think about this, agains thanks for ...

are you talking about the a-spec that is located in wis, onalaska??
cuz if it is dun bother with them....their shop is hardly open i drive by it everyday.....they did a swap for 6gen civic hatch and it runs like crap...does not even run like a true grs swap.

hi guys,
I was just wondering if it would be possible to swap a 1gen mx-6 into a '93 SE. Any hints and tips would be grateful. i know that the 2gen mx-6 engine fits but i am wondering about the 1gen. I have a 1gen and when i purchase a new car i would like to swap that engine into my x3.
Again thank ...

i was wondering which company makes the best body kits and most durable.....i have gone through cork sport but it seems as though the front bumber is not very durable. i have thought about fx designs of onderground but i am not certain yet....since not that the front center part of my bumper has ...

i was just wondering saying as i have searched on this site but was unsucessful at it...its konda hard to read through several pages of stuff...

i was just wondering about that because i am sick of looking at the back end of these pontiac grand am's and grand prix's....not to mention the v6 mustangs......i also own a mx-6 gt but that is a junker and its kinda not worth fixing up...if possible i would like the best possible info on the best ...