MX-3.com

Should be there too.

check the special edition link on this site, http://www.mx-3.com/se/ there is a pic of the heated seat switches. As far as I know only canadian models of the Special Edition got the heated leather seats.
My American SE did not come with heated seats - I had to put in aftermarket.

I've taken it out before, not that hard but you must be careful as the ceiling is delicate and you have to pop some clips to get it out. Start from the front and work your way back. make sure the plastic parts are off so you can see the edges

It should not be too hard. I guess you would need to get a 94 or 95 slider control panel with the cables from a junk yard (can get one around $35) and route them to the heater unit and the blower unit. on those two I think you would need to remove the little servo motors. I've done this in reverse ...

yeah - thats the same part number I got. "MP9903SA-2nd Generation 1999-2003 Mazda
Protege, Protege 5, 1992-1997 MX-3, 1992-2000 Ford Escort and ZX2 Short Throw Shift Kit With Ball Bearings" Mines in and works great.

See you all sunday, Hope to see some new faces and the old ones too.
till then, happy cleaning.

Interested - push button<p>Side note: Switching from 93 slider to 94 push button I found out that the 94+ control panel is an inch shorter in width - so there may have to be 3 types. Nice job on the design so far, keep them coming.

the sunroof rubber surround is probably stuck to the paint, if you go back to see it, push up on the sunroof while pressing the open button. If it pops up and runs then its ok. The ticking is normal for the engine at this age, regular oil changes and the correct level will help. consider offering ...

direct from the prm site
http://www.prmracing.com/filter_clean.html
thats how I clean mine and I hope that helps you out

I'll keep both days open

The NY meet was one of the best I've been to so far. Thanx goes to Dee for organizing it and to all who came to the meet. I look forward to the next one.
Thanx for hosting the pics Vlad.
We need more pics, so those who took, (you know who you are) need to get them off to Vlad ASAP.<p>Enjoy the ...

check your stabilizer bar end links both front and rear. grab onto the bar and if you can move it - theres you problem/noise. I doubt the bushings are done - but possible. The front bushing are extremely difficult to get to btw. Rear bar is easy.

I'm still coming too.
cya all there

these are where I got mine:
http://www.autopartsgiant.com<p>should be able to get remanufactured though them and they'll take the old ones off your hands.

heads up on the heating/coooling air system. the 94+ had either slider control or electronic control. The slider control should work fine in a 93/92 with the 94 dash. However, if you go the electronic route, you need to replace the entire heating assembly(except the heating radiator) and the blower ...