Search found 22 matches
- July 6th, 2007, 10:17 am
- Forum: V6 Technical/Performance
- Topic: raspy exhaust
- Replies: 5
- Views: 398
raspy exhaust
i have a gs stock motor and i recently removed my cat converter and put on a flow master type muffler, my question is when i accelerate any rpm's over 3 grand i get a high pitch rasp (sounds like a honda to tell you the truth) and it annoys the hell out of me i know it didnt make the noise before i ...
- July 5th, 2007, 12:40 pm
- Forum: V6 Technical/Performance
- Topic: Cruise Control Troubleshooting
- Replies: 6
- Views: 523
- February 27th, 2006, 9:37 pm
- Forum: General Mazda MX-3
- Topic: the end of a legend...............my mx-3 has been totaled..
- Replies: 15
- Views: 1193
sorry for the loss i had totalted my last car it was a volkswagen golf the rod in the block shot out and went and sprayed oil on the headers the headers lit the oil on fire and the fire set the whole electrical wires ablaze the care blew up 100 yards from my house but now im happy cuz it led me to m...
- February 27th, 2006, 9:31 pm
- Forum: General Mazda MX-3
- Topic: Air Intake
- Replies: 12
- Views: 1382
- February 27th, 2006, 9:24 pm
- Forum: General Mazda MX-3
- Topic: My new MX-3 (ProjectGTR)
- Replies: 15
- Views: 1296
- February 27th, 2006, 9:18 pm
- Forum: General Mazda MX-3
- Topic: Cost of timing belt change
- Replies: 10
- Views: 494
well when i got my car the water pump and timing belt went so had to take those to a friends dads shop he told me when he took them off that the pulleys on the timing belt were bad and that the only way to get them was through the dealer that cost me about 350 for both pulleys but altogether it prob...
- February 27th, 2006, 9:08 pm
- Forum: General Mazda MX-3
- Topic: new mx3
- Replies: 3
- Views: 261
new mx3
hey whats up im new to this site so ... i just got a 93 mx3 its a v6, 5 speed and i wanted to know i see that there isnt too much aftermarket support for it, i was wondering is there any sites or places that have engine/performance parts? if not would it be worth it to custom make stuff? thanks for ...