Epic burnout fail - 10/10 on the fail scale

[MX3-4U2NV]

Idiot neon driver...

http://www.ebaumsworld.com/video/watch/80909664/" onclick="window.open(this.href);return false;

[solo_ryder]

Haha.. A buddy of mine showed me that the other day.. Can you not feel/hear the tires spinning? Ugh...

[fowljesse]

Yeah, that's a good one. Nice windshield, too. I think it was done on purpose. There should be a section for Purposefail.

[slayer322]

lol, something definitely tried to go through the hood.

its funny when he looks under the car for some reason, doesnt pay attention to the most likely area of issue, like that new 2 foot cowl hood he now has

edit: i just watched it again, you can hear some clunking nice a hard until it comes to a complete "im done" stop lol

[Nd4SpdSe]

Ya, loved the plastic-tapped up side window and the mis-matched rims...Considering he can't even afford to replace a window I doubt he can afford to replace his motor...

Mind you, something doesn't look right with his hood beforehand...

[Daninski]

I think the spindle rowbin didn't mesh with the grapple grommets.

[MX3-4U2NV]

Ya, loved the plastic-tapped up side window and the mis-matched rims...Considering he can't even afford to replace a window I doubt he can afford to replace his motor...

Mind you, something doesn't look right with his hood beforehand...

He has a semi-cowled after market hood. or should I say had...

[mitmaks]

Gotta suck having this idiot having as a neighbor. what a tard

[RS_OBD'oh_2]

at least it was no loss. I'm not sure what he was even doing. Auto brake stand? E-brake burnout?

[Ryan]

Was the car auto? I can't excatly tell, although I would guess not. Auto brakestands are best done by revving the s--- out of it in neutral with the ebrake and footbrake on, and then slamming it into a low gear, and letting go of the brake, leaving the ebrake on


This guy..... not sure what he did. Slippy clutch? no rev limiter on that motor, just maxes AF but the sounds of it.