Page 1 of 1

gotta secand mx3

Posted: December 15th, 2009, 1:26 am
by mccabe
so i gotta new car and its loaded but got some questions

first or my new car has a klze butit came iwth the enous 800 trany and clutch drives fine and has the right ecu.

my other car had a kl01 but seemed real strong for a de it was alot like solo it the back car of his, are there any better parts on my de then the ze?

Re: gotta secand mx3

Posted: December 21st, 2009, 3:27 am
by fowljesse
I'm not sure what the question is, but I have a N/A DE that's stronger than most N/A ZE's. Did you do some serious modding (Pistons, cams, etc..), and have the Eprom configured righton your DE? DE's strength can be noticeable in regular driving, since the torque can be strong, and lower in the RPMs. Also, you could gave bought a tired ZE. Did you do a compression test? You could also get emmisions done, and figure your MPG, to see what condition it's in, as well as checking all the tune-up parts for wear (and especially check the spark plugs for a rough AFR estimate. Finally, have someone who draves about the same as you, race you, doing 2 or more passes in each car.