MX-3.com

I am looking for the belt adjuster, from the water pump to the power stering pump, its white metal and has a peice of threaded stock which provide tension to drive the pumps. any help would be great, just PM me, I will post a pic later. I also need the signal light swich, when i turn on the lights she will blow the fuse and the left signals are lit all the time, anyone else have this problem? can't wait to get her running again

A common mistake people make is to ground the deck using the car's parklight or dimmer wire. This wire shows ground normally, but 12 volts when the lights are on. This is what blows the fuse.
could this be the problem witht he park lampos i wonder and the signals? or dop u guys think it is in the switch?

cgreen84 wrote:A common mistake people make is to ground the deck using the car's parklight or dimmer wire. This wire shows ground normally, but 12 volts when the lights are on. This is what blows the fuse.
could this be the problem witht he park lampos i wonder and the signals? or dop u guys think it is in the switch?

That's my quote, I specifically remember typing that. Anyways...have you installed an aftermarket deck recently, or around the time this started happening??

you can get that adjuster iff any probe gt, mx6 or v6 mx3 at the yard. ive replaced mine once lol

Any reason why your replacing that pulley tensioner? if you snapped the bold, you can still turn it till it tensions the belt... its really doesn't matter.

But yeah and KL engine from any of these cars are the same.

the white metal bracket broke and yes i did change my deck

call all yards here in newfoundland today, no dice damnit! back to the hyundi boooooo

Nice to know I'm not the only mx3'er in Newfoundland

Sorry i can't help though.

anyone know where i can order one on the net???

cgreen84 wrote:the white metal bracket broke and yes i did change my deck

Rewire your deck's groundwire to a proper ground, that should solve your lighting issue.

thanks, any word on the name of the part i need? Anyne have the part #?

1994 Mazda Mx-3 ... need water pump belt tension assembly ( brace , pulley , and manual adjuster)

I got one for sale...but shipping to you might be expensive.

PM me your address and i can check it out.

-Devin

its actually the one circled in yellow

I am located in St. John's NL, postal code A1A 5H2, whats the cost, I'll buy the two of them if u have both. Also I need a signal light switch