Page 1 of 1
2.3l Miller Supercharger on k8..
Posted: March 12th, 2007, 5:57 am
by kenken
can the 2.3l supercharger fit nicely on the k8 engine?
Posted: March 12th, 2007, 8:27 am
by verzutiko
Probably no.
Use the Search function. If it has not been done before, it is probably very difficult/ impossible to do. At least impossible if you don't have unlimited funds...
Posted: March 12th, 2007, 12:48 pm
by Mnemonic
the answer is no. the engines are just to different to swap over, the angles of the heads varies greatly
Posted: March 12th, 2007, 6:21 pm
by atlantamx3
verzutiko wrote:Probably no.
Correction: DEFINATELY NO.
Posted: March 12th, 2007, 8:07 pm
by ccreech
Perry Has diagramed nicely why it won't work here:
http://www.mx-3.com/phpbb2/viewtopic.ph ... 37&start=0
5th post down when I searched "2.3 Supercharger" and that included this post.
I will sumarize:
Won't fit between the heads...So won't fit under hood...even if it would it is not your typical supercharger and would take a lot of modification. Actually...It would take more modifying to make it work than just about any other supercharger that you could possibly think of. They all would take a good bit of engineering to run from a drive belt, but it can and has been done with other superchargers. I would suggest going a different route. A picture is worth a thousand words...Look at how big it is and try to find a spot for it under the Mx-3 hood with the pully facing the belts.
