Lights help!
-
Sparky75
- Regular Member
- Posts: 108
- Joined: February 11th, 2002, 2:01 am
- Location: Northampton England
Lights help!
Hi all, got a problem.<BR>My front parking lights will not work, i have 2 separate bulbs in the front bumper, one for signal, and the parking lights. Does anyone know where the wiring comes from in the car and what colour wires?<BR>also i see from your pictures that you also have lights in the rear bumper behind the red reflectors, are they a factory fitted item?<BR>I think my car has been altered for UK laws but i still want them hehehe.
My MX-3 (Presso Eunos) 93 spec Right hand drive.<BR>Mods..<BR>Sullivan racing Alluminium Race Pedals.<BR>17x7" MB Molini Alloys with 215/40/17 tyres.<BR>Glass headlight/one smashed
<BR>PRM Intake Kit.<BR>Front Strut Brace.<BR>Erebuni Bodykit & GTR Rear Spoiler on the way.
-
mazdamxstyle
- Regular Member
- Posts: 559
- Joined: January 21st, 2002, 2:01 am
- Location: Ashland,Or.
- Contact:
Re: Lights help!
I know this might sound stupid or basic but have you checked the fuses?
1993 Mazda mx-3 GS - Blaze Red (Totaled) Went through an 89 rx7 and a 93 del sol. Now searching again!
http://www.cardomain.com/id/mxmisl
http://www.cardomain.com/id/mxmisl
-
Sparky75
- Regular Member
- Posts: 108
- Joined: February 11th, 2002, 2:01 am
- Location: Northampton England
Re: Lights help!
yep all fuses and bulbs ok
My MX-3 (Presso Eunos) 93 spec Right hand drive.<BR>Mods..<BR>Sullivan racing Alluminium Race Pedals.<BR>17x7" MB Molini Alloys with 215/40/17 tyres.<BR>Glass headlight/one smashed
<BR>PRM Intake Kit.<BR>Front Strut Brace.<BR>Erebuni Bodykit & GTR Rear Spoiler on the way.
Re: Lights help!
The same thing happened to me. Except my turn lights worked, but the parking lights didn't work. The previous owner had installed fog lights and nicked a wire. I found it by pulling out the side marker lights and the turn lights and pulled the wire all the way out of the car. There is a connection before the turn light. Well right where the connection was there was a little nick that had gotten wet and it corroded the connection. All I did was cut the connection out and hardwire the wires back together then made sure it was water tight. That seemed to have fixed the problem.