Indicator lens broken

General Mazda MX-3 Discussions
Post Reply
User avatar
petekav
Regular Member
Posts: 40
Joined: October 13th, 2005, 11:29 am
Location: Galway, Ireland

Indicator lens broken

Post by petekav »

Guys, my fiancee's stupid sister has reversed into my beloved MX-3! :evil:

'93 E-Spec V6 in Black. The bumber is damaged, but I think it will polish-out; the main damage is to the driver's-side front indicator unit. This unit is held in by one screw, has a clear lens on the front, and two bulb-holders at the rear: one for the sidelight and one (complete with orange insert) for the inidicator.

I have already called most breakers yards in Ireland, with no success, looking for a replacement. Maybe I could try the UK, but I was wondering if this unit is used on any other (more common) Mazdas, 323 etc. ?

The E-Spec MX-3 is very rare in Ireland - most are imported J-Specs.

The unit can be seen (with sidelight illuminated) directly below the headlight in this photo:

Image


Just below this again is the front towing eye. Thank God it is there; I think more damaged would have been done otherwise!!!

Any suggestions on sourcing a replacement would be much appreciated.
Stock '93 V6.
User avatar
neutral
Supporting Member
Posts: 1770
Joined: December 27th, 2004, 10:19 am
Location: U.S. Mid Atlantic

Post by neutral »

If you can't source this part on your side of the pond, here is one alternative for a U.S. based supplier. g/l

http://corksport.com/store/category/53g ... _misc.html
Image -Jim
User avatar
verzutiko
Supporting Member
Posts: 355
Joined: July 3rd, 2004, 2:01 am
Location: Norway

Post by verzutiko »

I think there is an MX-3 in a breaker yard in my vicinity. I could check it out for you, but it may take some time.
'92 GS
My worklog
User avatar
petekav
Regular Member
Posts: 40
Joined: October 13th, 2005, 11:29 am
Location: Galway, Ireland

Post by petekav »

Thanks guys!

After following that URL I can confirm that I need the beige housing as well as the lens.

Image

$150 (not including shipping from US to Ireland) seems pricey!
I must be able to source from a breakers yard somewhere closer to home.

At least I know where I can buy them now if all else fails...

I'd still like confirmation if anyone knows if the same units can be found on other Mazdas.

Pete.
Stock '93 V6.
User avatar
garfy1981
Regular Member
Posts: 288
Joined: September 27th, 2004, 2:01 am
antispam: ~SPAM*SUX~
Location: UK, South-East
Contact:

Post by garfy1981 »

http://www.mx-3.com/phpbb2/viewtopic.ph ... highlight=

goo see mazda dont know the rrp on the part but will be alot less.
2.5 Ze straight neck, blitz intake, mazdaspeed engine mounts, fidenza flywheel, CM II Clutch, KL-36 ecu, Magnecor 8mm Leads, Battery Relocation. Hotshot headers, 2.5 mandrel bent stainless exhaust, hi-flow cat, Speed hut dials, custom coilover set up. Custom willwood big brake conversion.
Post Reply

Return to “General Mazda MX-3”