Strut Mount from MX6

andyvich · Post by **andyvich** » February 3rd, 2005, 4:13 pm

Will the strut mount, from an MX6, which is a little thicker than mine, work on the MX3? my buddy with a late80's early 90's mx6 says its the same as escort and protege, which means it would fit? anybody offer advice?

Teal_93 · Post by **Teal_93** » February 3rd, 2005, 4:22 pm

All strut mounts are identical for all of the forementioned cars (Protege, 323, Tracer, Escort, ZX2 and MX3).

andyvich · Post by **andyvich** » February 3rd, 2005, 4:26 pm

i dont see mx6 in that list haha

Teal_93 · Post by **Teal_93** » February 3rd, 2005, 4:27 pm

I didn't see it either

RoundTop · Post by **RoundTop** » February 3rd, 2005, 5:13 pm

I don't see ford probe either, which is the Ford version of the MX6 (longer front nose, no spoiler). So I would say no.

Teal_93 · Post by **Teal_93** » February 3rd, 2005, 5:21 pm

if he has a spare one sitting around you could try it, but i doubt it would fit.

TsiMiata · Post by **TsiMiata** » February 3rd, 2005, 9:20 pm

I think it fits. When I ordered my ground control camber/caster plates I remember the guy saying they were the same as the MX-6. I just checked their website and they only list the 1st gen MX-6 for the camber plates. So from that I'd think they are the same.

Steeb · Post by **Steeb** » February 5th, 2005, 12:49 pm

2g mx6 n probe mounts will fit but it will raise your car like 1/2 inch. i dont know about 1g cars

andyvich · Post by **andyvich** » February 5th, 2005, 5:08 pm

Steeb wrote: it will raise your car like 1/2 inch.

exactly