My exterior look

maniacle_mx3 · Post by **maniacle_mx3** » May 27th, 2002, 4:14 pm

My exterior will have a Corksport Front Bumper and side skirts, a FX Designs Hood Scoop and a FX Designs Combat Wing. If all of these were installed do you believe that there would be any reason to lower it after I get my 17 inch rims put on. Also, does anyone know where I can get some Z3 fenders or a piece to make the wheelwells extend outward more.

finchuck · Post by **finchuck** » May 28th, 2002, 5:07 am

i think lowering it would be the finishing touch

mx3man18 · Post by **mx3man18** » May 28th, 2002, 8:57 am

Drop that s--- to the ground!!

SmokyMcGee · Post by **SmokyMcGee** » May 28th, 2002, 11:27 am

This place has alot of peices you can customize to your car. And you'll also find those fender flare things you put to extend your wheel well. <A HREF="http://prototype.packetlag.org/" TARGET=_blank>Team Prototype</A>

DDO49 · Post by **DDO49** » June 2nd, 2002, 3:04 pm

You need to drop it, when I got my 17"s it looked horrible because of how high the car was, just drop it the right way, new springs shox, coil overs, etc.

DDO49 · Post by **DDO49** » June 2nd, 2002, 3:09 pm

Also with the corksport front it is almost as short as the stock front so If your going to get skirts hope they don't go lower than your front. go to the website that shows my car with 17 's and the corksport front. The bumper isn't very strong either try to reinforce it with fiberglass before you put it on.<P>

MX-3.com

My exterior look

My exterior look

Re: My exterior look

Re: My exterior look

Re: My exterior look

Re: My exterior look

Re: My exterior look