KLZE STATS
KLZE STATS
i know i have asked this before but i only got 1 replay. So here goes. Can every one who has the KLZE engine in there mx-3 tell me what stats they have i.e 0-60.1/4mile. BHP(dyno,ed)top speed
Pakfeifer new front bumper, Pakfeifer new rear bumper, Pakfeifer new side skirts, Pakfeifer new bonnet, Pakfeifer new rear spoiler , Pakfeifer rear clear lights, Lowered 60mm all round, 75bhp of Nitrous, Green induction kit,18 inch wolfrace chrome alloys , Twin exit exhaust, Full two tone leather interior, One off custom ice install, Mondena corsa steering wheel, sparco gear knob, richbrook gear handle, white dials, sparco red and silver pedals,
-
TsiMiata
- Regular Member
- Posts: 1074
- Joined: July 30th, 2003, 2:01 am
- Location: Cape Cod, MA
- Contact:
Re: KLZE STATS
I got a 14.7 1/4 mile. Car is running a bit lean and vris points aren't right. top speed is 113mph since the jspec ecu limits it. You can bypass it, I just haven't.
93 MX-3 GS- ZE, KL31 ECU, Fidanza Flywheel, CM Stage 2-R clutch, Hotshot Headers
99 Subaru Impreza RS, the new toy
91 Eagle Talon Tsi AWD *RIP*
99 Subaru Impreza RS, the new toy
91 Eagle Talon Tsi AWD *RIP*
-
babyblueMX3
- Supporting Member
- Posts: 3755
- Joined: February 23rd, 2003, 2:01 am
- Location: Gatineau,Quebec,Canada
- Contact:
Re: KLZE STATS
did a 14.8 without vris number 2 working on crappy tires..Oh it was my first time.. I'm going again tomorrow I'll post you my new times
RIP 400whp ZE-T MX-3
Current car : Golf 01 GTI 1.8T (15 psi)
Current car : Golf 01 GTI 1.8T (15 psi)
Re: KLZE STATS
If you are Turboed vouldn't you disengage theOriginally posted by babyblueMX3:
did a 14.8 without vris number 2 working on crappy tires..Oh it was my first time.. I'm going again tomorrow I'll post you my new times
vris? I would really think you could have done a lot better with a turboed ZE.
But I don't have one so I don't know.
Odds
Odds, Norway
Red `93 GS, Stock
Red `93 GS, Stock
-
babyblueMX3
- Supporting Member
- Posts: 3755
- Joined: February 23rd, 2003, 2:01 am
- Location: Gatineau,Quebec,Canada
- Contact:
Re: KLZE STATS
lol..that's because the turbo isn't in yet..it's a project I have..Now I have ze with UR pulley, 13pound FW, 67mm TB, 2.25" cat-back, pheno spacers, hi-flow cat....pretty much it
RIP 400whp ZE-T MX-3
Current car : Golf 01 GTI 1.8T (15 psi)
Current car : Golf 01 GTI 1.8T (15 psi)
-
PATDIESEL
- Senior Member
- Posts: 4476
- Joined: August 13th, 2001, 2:01 am
- antispam: ~SPAM*SUX~
- Location: Atlanta, GA.
Re: KLZE STATS
My top speed is about 135. But the stock speedo isn't going to be correct at that speed. Tranny limited (redline in 5th gear), and hauled *** all the way to 135MPH. Racing a RSX Type S. ZE and a 1.8L tranny.
ZE -strait neck,headers,2.5 exhaust,pheno spacers,lower cross member,GC coils,MS struts,Brembo slotted rotors,filled MS mounts,SS brake/clutch lines, CAI,to rear bat reloc,Hella headlamps,Hella DE fogs 180WHP
-
Jeff_Jeske
- Junior Member
- Posts: 10
- Joined: May 15th, 2001, 2:01 am
- Location: Stevens Point, WI
- Contact:
Re: KLZE STATS
Well you should be able to yank 13s with sticky tires...what are your cars weighing in at?
The PGT race weight of 2600LBS is pulling consistant 14.1s at 98 with a 2.0 short time.
I am curious what the best MX3 ZE run is because I am hunting for an MX3 with the swap.
The PGT race weight of 2600LBS is pulling consistant 14.1s at 98 with a 2.0 short time.
I am curious what the best MX3 ZE run is because I am hunting for an MX3 with the swap.