i saw the vid to the Uber-turbo V6 MX-3 (the 300 hp one, forget the owners name), what radiator did he use for a upgrade, im looking for a rad that would be simple to make it fit, any suggestions?
<small>[ May 23, 2004, 03:37 PM: Message edited by: papa roached ]</small>
Radiator
- papa roached
- Senior Member
- Posts: 2761
- Joined: December 10th, 2002, 2:01 am
- Location: Montgomery, WVa
Radiator
93 MX-3 GS (collecting parts for Eunos Presso conversion), 94 626 Transmission (4.10 gears), KL31 camed KL-ZE, Millenia intake, Millenia TB, SSAutochrome V2 headers, Magnaflow cat, 2 1/4 in pipe, Top Speed Pro 1 muffler, 9lb Fidanza Flywheel, ACT clutch, Corksport SS clutch line, Corksport SS brake lines, Unorthadox UDP, 255 lph fuel pump, HEI mod, ghetto-charger intake, KL36 ECU, SRD transverse crossmember bushings, SRD shifter extention bushing, SRD crossmember, Corksport bronzoil shifter bushings, Brembo Crossdrilled and Slotted rotors, 15 inch Konig Heliums, ZX-2 S/R struts, Eibach lowering springs, OEM front strut bar, Ebay rear strut bar, BFGoodrich G-Force T/A KDWs
Parts needing installed: turbo kit from BB (if i ever get it), 9.0:1 CR Diamond pistons, 4340 forged H beam rods, C/J-Spec spoiler, Nissan red tops in KL rails
http://www.cardomain.com/id/blazejeremy
Parts needing installed: turbo kit from BB (if i ever get it), 9.0:1 CR Diamond pistons, 4340 forged H beam rods, C/J-Spec spoiler, Nissan red tops in KL rails
http://www.cardomain.com/id/blazejeremy
- goldsberry1
- Regular Member
- Posts: 260
- Joined: November 30th, 2002, 2:01 am
- Location: greenville, nc usa
- Contact:
Re: Radiator
i know there is one for the probe gt and mx-6. i'm not 100% sure if they will be a exact drop in for our cars though. they are all so around $500. i cant remember the website. it was on my other computer that my wife took off with. but they are out there, somewhere.
92' mx-3 gsr, built engine, forged internals, p/p ze heads. t3/t4e .63/.60 turbo, udp, msd ignition, millenia s injectors, millenia im, water cooled intercooler, afpr, fmu. running at 7 psi right now
-
- Regular Member
- Posts: 132
- Joined: September 12th, 2001, 2:01 am
- Location: guelph, ontario, canada
- Contact:
Re: Radiator
best bet is to measure what available space you have and then go shopping at a wreckers yard wit your measuring tape. youll probably end up with a wicked one for cheap..