MX-3.com

i think that would rock, i'm not planning on changing mine. im puttin on some yoko rubber and repainting it either blaze red or like the newer mazda miata/rx-8 red. sleepers kick ***

Link 1

Link 2

these guy's have a pretty good variety...or you could go to psituning and look under mx-6 clutches, since you'll need one to fit the 2.5L

go w/a 4 or 6 puck...those are the best for race applications

On the track we do it off the rev limiter.

how do you do that? i've got a 5spd gs and have gone over 7k(maybe 100-200 over) before but the needle kept on going, so i let off....it was as if there was no limiter.

am i just a wuss?

im in indianapolis IN but i've never done the swap, keep looking, you'll find someone. i'm wanting to do the same thing, a much more rewarding experience to actually take part in the swap yourself!

where on God's green Earth did you find that motor??!!

that is one shiny ZE, and you'd better get those kl31 cams!

i wish a 2rotor could fit...(for less then 20k) let alone that bad boy.

the thing sounds like a v-8!

went out and did 5 'test runs'. made vids, came back and stopwatched the video. (they came out like crap) best time was 8.5, worst was 9.8. stock gs

thanks guys

im just about to get a short thrower for my mx cuz i found one for 94 bucks! but i havent done the ze swap yet, and plan to in the next 6 months. should i hold out? ie. am i going to need to get another one when i do the swap or will it swap over? if i keep the mx-3 tranny i should be able to keep i...

i've been thinking about the rear wiper, but that headlight is getting cleaned up for sure!!!


the "bite" in my back bumper, is a trailer hitch from the previous owner.

my bumper looks like its starting to come away from the rest of the car, starting at the headlights. where are the bolts located to tighten it up? it doesnt look serious, it looks like i just need to tighten it up a bit.

how did you remove the module from the back of the fusebox? i'll double check and make sure i pulled the right ones but im 90% sure i did [edit]just checked, yup, pulled the right wires. the 3 that were highlighted on the diagram. :shrug: <small>[ August 16, 2004, 02:09 PM: Message edited by: ZEmadm...

which engine is this? looks like a ze w/the kl101 cams?? any one else know?

if i get mine from them, i'll prolly just swap over my mx-3 MTX and sell the ze ATX, but for $900, it's a sweet deal.

oh no, there's plenty of roads i could test it out(i live in indianapolis, but im well aware of plenty of 2 lane highways that go on for days