MX-3.com

So everything was working fine then I blew a cam belt.

Changed heaps of stuff while car was out of action.

CAI, did a HEI + Coil and changed to curve neck intake on my ZE. I would have tugged at the wiring loom to relocate some things and I did stat the car with HEI + coil without a resistor a couple times. Resistor is in and tach works fine, I can see my revs no issue.

Just a dead speedo.

Any ideas, where should I look?

It's a 1995 Eunos 30x (mx-3 GS).

Speed sensor wiring from the transmission up to the cluster... its 2 wires off the sensor and they feed directly to the cluster.. you have 3 possibilities.. dead speed sensor, bad wiring, dead cluster.. take your pic..

Thanks for the fast reply! Do you know whereabouts the sensor is? I know of 2 gearbox sensors but I thought one was a neutral/clutch switch and one was a reverse switch? Or is there one more I don't know about?

Thanks again for your help!

On top of the diff by the passenger side axle...

Thanks, found it.

It was possibility 4: forgot to hook it up like an idiot.