Page 1 of 1
[WTB] Bp/b6 connecting rod(s)
Posted: June 21st, 2013, 10:14 pm
by RobMinhas
Looking to buy some bp or b6 connecting rods. I'd like two of them and so long as they aren't too too bent they should be good.
Can be worn, lightly cracked or scored. They aren't going in an engine, they're for a different project.
Gonna have to be shipped up to Alberta, Canada.
Re: [WTB] Bp/b6 connecting rod(s)
Posted: July 2nd, 2013, 9:52 pm
by jaydog is back
Would you like to upgrade to Carrillo H beams? I have a set of 4 for sale. For a BP engine. Let me know if you are interested or not.
Re: [WTB] Bp/b6 connecting rod(s)
Posted: July 2nd, 2013, 9:59 pm
by RobMinhas
Nah dude I'm just looking for some junk rods, like I said in the OP these aren't going into an engine they're just for a project of mine.
Re: [WTB] Bp/b6 connecting rod(s)
Posted: July 3rd, 2013, 1:00 am
by RS_OBD'oh_2
I have some from your old b6 sitting in my garage
Re: [WTB] Bp/b6 connecting rod(s)
Posted: July 3rd, 2013, 1:07 am
by RobMinhas
RS_OBD'oh_2 wrote:I have some from your old b6 sitting in my garage
Ohh even better, one from my old trusty B6 would be great.
If you're not gonna use them I'll buy them from you, I just need the connecting rods. I need to get that black car running then I'll get ahold of you and grab them since i'll have wheels then. How was that engine inside? Really curious.
Re: [WTB] Bp/b6 connecting rod(s)
Posted: July 3rd, 2013, 4:05 pm
by RS_OBD'oh_2
the engine was fine. There was typical carbon build up on the pistons, but looks great overall.