MX-3.com

trying to install my full length side skirts the hardware used for the mud guards doesn't work. anyone know the part numbers for the mounting hardware? no side rails with them, may use some double sided tape as well

which type? USDM/EDM (like on my race car) or JDM (like on my daily driver)?

I have the instructions I can send if you give me your email if they are JDM (and you can buy your own hardware), if USDM/EDM they need plastic rails to be done right...

Usdm ones

Double stick works pretty well. I used Stainless Steel self tapping screws where the mud guards mount, and underneath to the frame crimp.

Think you can send me for jdm? Thanks

pm me your email and I can send the PDF for the JDM ones (whoever needs it).

You're welcome

Nd4SpdSe wrote:You're welcome

... that orginally I got from Nd4SpdSe...

So just buy a generic hardware kit at advance auto or something? Was hoping to get stock PN for the hardware since both upper mounting points are broken on the skirts (only one mouning hole front/rear) was planning to use 3m double sided tape as well

Mike if you cant figure it out you can just sell them to me

91EscortGT wrote:Mike if you cant figure it out you can just sell them to me

Haha oh believe me I will figure it out, been waiting long time for these