MX-3.com

I'm just about to swap a klde into my gs but wanted to do the timing belt ad water pump before I put it in since the engine is just about 90k miles. Would you suggest I do the timing belt tensioner too? Because there are 2 separate kits one with it and one without, which the one with it is like another $60 or $70 which I don't mind paying, but would rather not if its not vital. Any suggestions?

Honestly well worth it and it takes ten minutes to do for piece of mind!

I say yes replace it

I say replace it if its been removed already, if it hasn't than reuse it- under the 1 condition that you have a table vise on hand, aswell as a small drillbit or paper clip. When you take those things off they need to hit a vise IMMEDIATELY. turn the vise slowly when you compress it until you can get the drillbit or paper clip in to hold the ram down. I reuse them all the time, despit what people say. You just have to be careful with them & time is important to get it into a vise.
Well it does take 10 minutes but it also costs $60-100- if you get it for $60 you're waiting on shipping, $80+ is what my local parts stores charge for them

I got lucky and found one for 44 dollars on ebay. The next day it went up to 60 dollars.

Ebay has some good deals on them. And yes, you should change it.