Page 1 of 1
GC's On ZX2 struts
Posted: February 7th, 2012, 11:19 pm
by Thefez
Ok so as some might have seen I put my GC's on ZX2's up for sale because of the gap between the springs and strut tops boths me.. I've been reading about "preloads" or "Helper Spring". This looks like if I could find a cheap set of these i'd keep my GC's on ZX2's
Re: GC's On ZX2 struts
Posted: February 8th, 2012, 1:27 am
by Josh
There are several places you can buy either. H&R is probably your best bet, but you will have to call them as they do not list them on their site. The set of 4 with perches ran me about 250.
Re: GC's On ZX2 struts
Posted: February 8th, 2012, 7:40 am
by Thefez
Josh wrote:There are several places you can buy either. H&R is probably your best bet, but you will have to call them as they do not list them on their site. The set of 4 with perches ran me about 250.
What info did they need from you? and what other places can I buy them from options are good
250 isn't bad at all just kinda wana see other quality/price options
Re: GC's On ZX2 struts
Posted: February 8th, 2012, 6:47 pm
by mikeinaus
you shouldnt need the preloads. dont get me wrong its probably nice to have them but there not necessary. solo_ryder ran ground controls on zx2 struts for years without preloads and never had problems.
Re: GC's On ZX2 struts
Posted: February 8th, 2012, 10:54 pm
by Thefez
mikeinaus wrote:you shouldnt need the preloads. dont get me wrong its probably nice to have them but there not necessary. solo_ryder ran ground controls on zx2 struts for years without preloads and never had problems.
Theres a ton of guys that run them on zx2's without them but i want them for my peice of mind.