MX-3.com

My mx-3 doesn't have washers installed on the hood. I'm thinking about this kit. Does it looks it will fit?
http://www.ryderfleetproducts.com/ryder ... tDetail.do

http://www.dormanproducts.com/p-19919-47135.aspx

Use these, I have them for my carbon hood, theyre from the old 80s gms and lock onto the arms easily, Ill try and post pics tomorrow for ya.

This is an awesome idea. I've been thinking of this for years. I hate our stock squirters, I am so jealous of the fine misting spray that the GF's honda does. Ours is useless, even after being properly aimed.

When I got my CF hood, I put the squirters in the wiper cowl, could always use squirters from any vehicle really

Sleeper6 wrote:http://www.dormanproducts.com/p-19919-47135.aspx

Use these, I have them for my carbon hood, theyre from the old 80s gms and lock onto the arms easily, Ill try and post pics tomorrow for ya.

How did you mount them, can you post a pic please?

This is the drivers side, I added the extra one for more spray, its just on with a piece of mechanics wire but Im going to pick up some metal banding and redo it so it looks stock.


This is the passenger side, once it warms up to make it 100% stock looking I plan on pulling the arm off and boring a hole in the lower part of the arm that hides the spring and feeding the washer tube through there like they used to, then there will be no zipties!

You can probably run tubing underneath the arm and just glue it with maybe some epoxy glue? That would really clean it up and repaint wiper arms

good thing you asked for pics before pulling the trigger on that one...

Why can't squirters be mounted in the wiper deck, out of sight?

you can now buy aero wiper blades
with intergrated jet kit off ebay!

ninjajim4 wrote:good thing you asked for pics before pulling the trigger on that one...

Hey! Seriously though I only posted these to show how the nozzles clip on, the install can be done much cleaner, I just put these on using what I had on hand so I could use my hood as winter was fast approaching and I didnt have funds to do it right. Using the smaller diamater plastic tubing and running them through the arm with a small hole they look much much better, just google a late model oldsmobile and youll see a better pic.

ninjajim4 wrote:good thing you asked for pics before pulling the trigger on that one...

that's still BETTER what I have, cause I don't have anything since Ive installed c/f hood ( I was a dumb kid wasting my money)
Every time my windshield gets dirty I have to wait till rain hits it or splashes from oncoming traffic lol

youdirtyfox wrote:you can now buy aero wiper blades
with intergrated jet kit off ebay!

Please post a link if you can find a set for mx-3. thanks

youdirtyfox wrote:http://cgi.ebay.co.uk/FLAT-WIPER-BLADES ... 20aa2c481e

I've seen those before, they're way too expensive imo and have to come all the way from Britain.