Page 1 of 1
No cam sensor input on MS2
Posted: March 26th, 2011, 8:46 pm
by mx3worthy4link
so i got a crankshaft signal to MS, but I cannot get a camshaft signal in the composite datalog. I tested the voltage at the #3 pin of the DB37 connector and its seeing 0-5 volts on cranking but I still have no signal, anyone have any ideas?
Re: No cam sensor input on MS2
Posted: March 26th, 2011, 11:19 pm
by Daninski
What's the part number on your disty? Is it TOT57071 or TOT57072.
Re: No cam sensor input on MS2
Posted: March 27th, 2011, 9:07 am
by mx3worthy4link
TOT57072
Re: No cam sensor input on MS2
Posted: March 27th, 2011, 9:50 am
by Daninski
I was just checking in case you had a newer disty with no cam sensor.
Re: No cam sensor input on MS2
Posted: March 27th, 2011, 10:27 am
by mx3worthy4link
yeah like I said megasquirts seeing 0-5v going into the board so its working but the unit isnt picking it up :/ i cant figure out why