MX-3.com

Hello!

I am completely new on mazda world and in this forum.

I have recently bought a 1.6 16v with a rough idle...

I have been trying to test my car but the pins in the diagnostic box are not labeled so i´ve been searching and found this http://www.youtube.com/watch?v=IU4uOHatUR0 video. Are these the correct pins that i have to use?

In this case my CEL doesnt light at all (neither when i put the key in on mode), is that correct.

regards.


Pd. Apart from this what specific tools are used to remove the TB?

Where are you located?

I am from Spain (europe)

Does the pins depends on where the car has been made?

I don't know, thats why I didn't really want to answer, hoping one of our UK members would.


In NA, we use TEN and GND if your car is pre OBDII (95/96 ish) but OBDII might have started earlier in the UK... idk..

Ah ok thanks anyway

The problem is: the pins in my diagnostic box are not labelled...

I can't say for you guys in Spain, but over here in the US those are the correct pins to use.