Page 1 of 1
engine mounts
Posted: February 28th, 2010, 3:25 pm
by ramsen25
anyone know where i can buy performance mounts something better then factory
Re: engine mounts
Posted: February 28th, 2010, 3:47 pm
by Muzzled
AWR motor mounts
AwrRacing.com
Re: engine mounts
Posted: February 28th, 2010, 6:39 pm
by ramsen25
i take it i would use the mx6 mounts cuz there no mx3
Re: engine mounts
Posted: February 28th, 2010, 8:08 pm
by Muzzled
look harder lol..... sheesh people are lazy and dont wana bother looking further than 6 inches in front of their face...
i just clicked on the site, went to products and pulled up the mounts lol........
http://www.awrracing.com/store/index.php?cPath=107" onclick="window.open(this.href);return false;
probe front/mx3 rear is what i went with. 88D' for now getting the 95's later on.
Re: engine mounts
Posted: February 28th, 2010, 8:12 pm
by solo_ryder
They are there ramsen. As Greg said, probe front mx3 rear. 88a is good streetable durometer
Re: engine mounts
Posted: February 28th, 2010, 11:21 pm
by ramsen25
ahaahahahahaha man im serious i didnt see them
Re: engine mounts
Posted: March 1st, 2010, 10:06 am
by Bolverk
Just curious why you'd get the probe front mount? Looks the same as the MX-3 one in the pictures.
Re: engine mounts
Posted: March 1st, 2010, 10:25 am
by marcdh
Ironically better fitment, unless they revised the mx3 front design.
Thread explaining it
solo_ryder wrote:
The reason why I and others say use the probe front is because awr obtained a front mount from mazda to make their mount for the mx3. For some reason they received and replicated a mount that is too skinny. My buddy has a mx3 mount and he has to run about 6 washers on each sidev of the mount to make it fit snug. Not a big deal, but the probe one does fit better.
Get the probe front and you just widen your xmember holes by a few mm, 2mins with a drill, easy!