Page 1 of 1
cross member
Posted: April 14th, 2008, 9:32 pm
by slinkymx3
i have a probe turbo kit with just the turbo pipes basically...and i was wondering since i had to bend the piss outta the cross member why doesn't anyone make a x-member for a turbo set-up???? i mean it only has to support 2 mounts and connect to the frame any thoughts?
Re: cross member
Posted: April 14th, 2008, 11:19 pm
by Mnemonic
because most people just take it to a shop have them cut and bend to accommodate for the pipe. Cheaper than paying for an after market cross member and just as effective.
Why spend 100s when you can spend 50
Re: cross member
Posted: April 15th, 2008, 8:58 am
by slinkymx3
ehh i guess just a thought thats all
Re: cross member
Posted: May 18th, 2008, 5:22 pm
by Flinch
hey im just wondering what the stock measeurement is from motor mount to motor mount is cuz i am in the middle of a turbo project with a cut cross member and didnt think to measure that befor i modded it. if somone could let me know that would be great.