Page 1 of 1
Was this head gasket blown?
Posted: April 5th, 2008, 7:36 pm
by Mi|<E
Re: Was this head gasket blown?
Posted: April 7th, 2008, 6:03 pm
by Bumpysbro
this looks just like how mine was. i dont see anything blown between the cylinders, did you have lots of white smoke or low compression?
Re: Was this head gasket blown?
Posted: April 8th, 2008, 12:09 am
by Mi|<E
Bad compression, its getting replaced with a BP anyway.
Re: Was this head gasket blown?
Posted: April 8th, 2008, 4:33 pm
by Bumpysbro
ahh nice good luck with the swap. you using the bp or the b6 tranny?
Re: Was this head gasket blown?
Posted: April 8th, 2008, 7:43 pm
by Limegreen mx-3
at least the bp uses a multi layer steel head head gasket compared to the composite gasket the b6 uses..
Re: Was this head gasket blown?
Posted: April 8th, 2008, 9:27 pm
by se7en
I gotta tell ya, Sometimes headgaskets 'go' and they don't leave any trace of where.
I have seen obvious head gasket problems, and the gasket looks fine.
It's weird sometimes.
7
Re: Was this head gasket blown?
Posted: April 8th, 2008, 11:15 pm
by Bumpysbro
ya same here, my b6 had the same issues. the ridges werent blown between the cylinders. can you special order multilayer b6 headgasket limegreen?