Page 1 of 1
clearing engine codes/ new starter? engine wont turn over
Posted: January 15th, 2008, 1:34 am
by studboy13
so im putting in my kl/klze (not sure which 1) and i think im done but my starter is doing nothing. do i need to clear my ecu codes. could that do it, i checked all my wiring and everything seems right, and the battery is almost brand new. it was trying yesterday but the battery was too low to acutally do it, i charged the battery and now this. any help?
Re: clearing engine codes/ new starter? engine wont turn over
Posted: January 15th, 2008, 1:40 am
by Smith18
there is a ground wire coming off of the distributor wire loom that needs to be grounded, sometimes my car doesn't start (like it almost has no power when i turn the key) and i have to wiggle this wire ( i have to ground it better).
Re: clearing engine codes/ new starter? engine wont turn over
Posted: January 15th, 2008, 2:10 am
by studboy13
where can i find this wire? color, size, location, anything?
Re: clearing engine codes/ new starter? engine wont turn over
Posted: January 15th, 2008, 2:22 am
by Smith18
its a little black/yellow wire that comes off of the distributor wire loom..
Re: clearing engine codes/ new starter? engine wont turn over
Posted: February 14th, 2008, 12:50 am
by studboy13
haha, funny thing about that wire, the previous owner cut it off at both ends. the only piece left it in the middle under a bunch of tape, where is the beggining and the end so i could replace it. and help[ would be apprieciated