MX-3.com

I found this on ebay.

"Trying to reinstall your factory radio? Were the wires cut? Then you need this harness. It plugs into the back of the factory radio.Our harness meets EIA color codes to take out the guess work out of what wire does what.

Make Model Year Span
MAZDA 6 2003 - 1994
MAZDA TRIBUTE 2001 - 2004
MAZDA MX6 1993 - 1996
MAZDA MX3 1992 - 1996
MAZDA MIATA 1990 - 2002
MAZDA PROTEGÉ 1990 - 2000
MAZDA MPV 1989 - 2003
MAZDA 626 1988 - 2000
MAZDA 929 1988 - 1996
MAZDA RX7 1988 - 1996




Don’t see your vehicle here, Click here to check out my store

EIA color code

Wire color - Wire function

Black - Vechile Ground (12V-)

Blue - Power Antenna

Blue/White - Remote Turn On (12V+)

Gray - Right Front Speaker Positive (RF+)

Gray/Black - Right Front Speaker Negative (RF-)

Green - Left Rear Speaker Positive (LR+)

Green/Black - Left Rear Speaker Negative (LR-)

Orange - Illumination/Dimmer

Red - Ignition/ Switched (12V+)

Violet - Right Rear Speaker Positive (RR+)

Violet/Black - Right Rear Speaker Negative (RR-)

White - Left Front Speaker Positive (LF+)

White/Black - Left Front Speaker Negative (LF-)

Yellow - Battery/ Constant (12V+)

If wires are not needed or unused simply tape off.

Guarenteed to fit vechiles listed in the application or refund."


Here's the link http://cgi.ebay.com/Reverse-Most-Mazda- ... otohosting

Just in case anyone is needing a new harness if some clown cut yours out.

This chart is WRONG. We don't have an orange wire in the stock harness.

Hasn't the proper one EVER been posted?

I used the one out of the manuals on this site, wouldnt ya know it worked perfect. takes a few seconds to read it but its 100% accurate