New sensor during swap
Posted: September 28th, 2007, 1:25 am
Hi
I am doing a swap from k8 to a KLDE with a ZE curved neck manifold. During the swap I came over som odd differences.
On the ZE it had an extra sensor on the intake.
And you can see that this is not to be found on the k8. (I also looked around for it other places)
But on the k8 there is a outlet that is not to be found on the ZE.. It's marked on the last picture.
But on the sensor on the ZE there is a outlet/inlet for another hose. Has this anything to do with it?
What should I do to solve the problem? Remove the sensor and use that (larger) outlet as the one I am missing?
I hope to get some answers as I didn't during my searching.
I am doing a swap from k8 to a KLDE with a ZE curved neck manifold. During the swap I came over som odd differences.
On the ZE it had an extra sensor on the intake.
And you can see that this is not to be found on the k8. (I also looked around for it other places)
But on the k8 there is a outlet that is not to be found on the ZE.. It's marked on the last picture.
But on the sensor on the ZE there is a outlet/inlet for another hose. Has this anything to do with it?
What should I do to solve the problem? Remove the sensor and use that (larger) outlet as the one I am missing?
I hope to get some answers as I didn't during my searching.