MX-3.com

Hey.. Im getting a bit confused here.. ok the valve seat... according to the diagram.. the little groove is supposed to be facing the valve right?

http://www.tialmedia.com/documents/w3_tial_wg_assem.pdf

?

And then the bottom portion bolts up tpo the exhaust manufold? It came with 2 flanges.. which i dont know what they are for..
heres a short video..

http://www.youtube.com/watch?v=Xmth4sLKo6g


Im lost ..

okay those 2 steel flanges you have are 35mm and 38mm so that you can fab. them onto a collector/ turbo pipe. all u need to do is bolt the bottom of the wastegate to the turbo pipes with the gasket given. and like stated above u can use the extra flanges to make a dump tube it u want to lower the exaust vent. sound.....hope that helps

where is the metal ring i didn't see one u need one or it won't hold boost it will either no boost at all or go over borad

Yeah I got the valve seat, i ahd it on backwards on the video. I guess it goes pressed to the pipes. It does seem to seal well.

make sure u put that on when the tyme comes