Page 1 of 1
K8 dist on ZE?
Posted: September 2nd, 2007, 2:36 pm
by Suresperance
i need to know if a K8 dist would work on a ZE. pretty sure mines shot and have a spare K8 one. if so how would i go about swapping them. any special instructions or any thing for proper timing?
Posted: September 2nd, 2007, 3:49 pm
by hgallegos915
are you being serious?
Posted: September 2nd, 2007, 4:02 pm
by mx3autozam
You have all those mods done to your car and don't know how to install a distributor..wow
Posted: September 2nd, 2007, 6:53 pm
by shab4life
yes it fits and its fine
Posted: September 2nd, 2007, 7:15 pm
by Vanished
mx3autozam wrote:You have all those mods done to your car and don't know how to install a distributor..wow
He may have well gotten it all done at a shop ahahah..
No honestly, I've been in the same position. I mean this is something thats not hard to figure out, but i've been in a position were there was something i just didn't know that i should have...it happens. Like the time somebody asked about what a engine lift and stand were for.
Posted: September 2nd, 2007, 7:19 pm
by Suresperance
yeah im serious dropping in an engine and doing bolt ons arnt that hard but im afraid of messing with the timing lol.
i do all my own work i couldnt afford to pay a shop to do it lol
Posted: September 2nd, 2007, 11:42 pm
by mx3autozam
just put it on in the same position. its not very hard.computer will adjust it if its a tad off. I've never ahd a problem.
Posted: September 4th, 2007, 10:50 am
by Suresperance
well its all done and works great motor is running better than it did in the other car. dist was the problem just put it back in the same spot and its great. thanks for your help now i just need to find the fitting i forgot to connect and is leaking power steering fluid all over. lol