Page 1 of 1
[WTB] ground control coilovers or used coilover suspension
Posted: May 23rd, 2007, 2:35 am
by 92gsrtwinturbo
like it says Im looking of a set of ground control coilovers or
a set of used coiovers, w/ or w/out struts
I am in MN
thanks
Jesse :D
Posted: May 23rd, 2007, 3:56 pm
by escortluver19
i have a set of two ground control coilovers in great shape.They have the eibach springs included.I have them installed on the front of my car right now but id like to get some regular lowering springs instead.Lemme know if your intersted.
Posted: May 25th, 2007, 3:55 am
by 92gsrtwinturbo
so you have a total of two springs, perches, top hats and sleaves,
Or do you have the compleate kit just not installed??
thanks
Posted: May 29th, 2007, 2:08 am
by 92gsrtwinturbo
bump
Posted: June 3rd, 2007, 10:37 am
by escortluver19
i have a complete set of two.I have two springs,collars,sleeves, and tophats.They are installed on my car at the moment, so i can send you pics if you want to see how low the car sits without cutting the perches.I think i dropped it about 2.5" which turned out to be very low.
Posted: July 6th, 2007, 8:27 pm
by invictus_92
I have a brand new set of TEIN BASIC COILOVERS (ford probe) for $830 shipped in lower 48 states only. LMK.
Posted: July 7th, 2007, 10:05 am
by DimaK
i do nnot believe that mx3 and mx6(probe) suspension is interchangable
Posted: July 22nd, 2007, 7:27 pm
by 92gsrtwinturbo
still in need of a set of ground controls, or others
used is great new is better :lol:
Let me know :D
Posted: July 22nd, 2007, 7:35 pm
by solo_ryder
If you really want some coilovers go buy some K-sports 323 gtx ones, they will work on a mx3, but they are pretty damn stiff.
Posted: July 22nd, 2007, 7:39 pm
by 92gsrtwinturbo
really? the full set up with struts and all? if so Im may just do that,
who do you know that has them? or what mod are reqired to fit
thanks :D
Posted: December 2nd, 2007, 2:41 pm
by teribble
DimaK wrote:i do nnot believe that mx3 and mx6(probe) suspension is interchangable
Mx-6 k sports will fit on a mx-3 you only have to do a few mods to make the fit. I know the fronts bolt right up you just need a washer or two for the botton. The rear - the top bolts are a little different so what you have to do is just line up on hole and drill two new one's but as for the bottoms you just need to get 2 washers too. not to hard of a mod. it has been done. slammed6 was the first one to do it!
Posted: December 11th, 2007, 12:10 am
by MazdaManiacMx3