Page 1 of 1
Not firing
Posted: April 3rd, 2007, 6:31 pm
by NeZmO
Hi guys. I found that when installing a ze that if you stick with the k8 ecu then you also have to swap out distributors and use the k8 distributor also. When I received my ze ecu today I found that my engine won't fire. Do I now need a 2.5 distributor or is it something else? Thanks guys
Posted: April 3rd, 2007, 6:39 pm
by Slammed6
Well u r suppose to use your disty from the original 1.8 on the new ZE. Also u will need to swap Crank sensors from the 1.8 to the 2.5, at least i had to.
Snapping in a KLZE ECU should be just that. No modification needed. It will work with the 1.8 Disty.
Posted: April 3rd, 2007, 9:00 pm
by NeZmO
Well I have almost put 3,000 miles on the ZE. I drive it 160 miles to and from work. Today after I got home I plugged it in and no dice
But I didn't have to swap my cps. The two connectors were identical one just longer than the other.