MX-3.com

Dont you think all this looks good with my connecting rods i got?

s--- those are some big rods. Never heard of those pistons but they look cool

I've never heard of those pistons either. But y the look of them they look pretty close to a ze piston...whas the specs on them??

.020 overbore, 9.0:1 compression, millenia rod floating wrist pin style, ceramic top coating

Those babies are made for boost!! Should be sweet Are you gonna dyno your car before and after the build for reference?

Tunes67

nah, one dynos are few and far between here and two a kl-ze with bolt ons has been dynoed quite a few times by the probers so i got an idea what im layin down

when u get that all done we need to meet up : )

What rings did you go with? Chromoly I am assuming.. but what brand?

Tunes67

plasmoly rings, looked and couldnt find anything about the chromoly or plasmoly and those were the 2 choices so i just picked one and they are total seal brand

looks dam good!

XxantwawnxX wrote:when u get that all done we need to meet up : )

most deff, 2 boosted ZEs rollin out together, the world isnt ready

Hmmm.. never heard of plasmoly rings before.. I'll ask my machinist about them and see what he says.. Did they give you breakin instructions with them? Just curious

Tunes67

not that i have seen but i really didnt dig into the box much, no real need to since i have nothing to put them in yet

[quote="papa roached"]not that i have seen but i really didnt dig into the box much, no real need to since i have nothing to put them in yet[/quote]

who did u lay to get that must have gave them the time of there life. J/K comming on up good luck