Page 1 of 1
Hatch (cargo) cover help
Posted: December 23rd, 2006, 9:10 pm
by markbrad
I am going to fabricate a cargo cover but need some help with the dimensions. What is the overall length at each of these dimension points, at the edge, at the angle and at the center indentation? How far from the edge is each dimension change? See my crude sketch. What is the pivot pin diameter? Thanks for any help.
[/img]
Posted: December 23rd, 2006, 10:11 pm
by PATDIESEL
That would be almost impossible to give exact dimensions on. The best idea would be to purchase a new one from someone on here, there is a company that makes a simple flat replacement version (don't remember who) or mold a new one from your old one out of fiberglass like I did.
Posted: December 23rd, 2006, 10:33 pm
by jschrauwen
I replaced mine over 11 years ago with MDF and just cut to fit the given measured dimensions and putting a radius on the rear part. Then with a thinner fiberboard I attached a lip/skirt to the rearward portion to make a better seal. I later used a speaker friendly fabric to cover the complete top portion which gave it an almost oem appearance. It made a great foundation to mount a free air sub and gives better sound deadening from the rear cargo area. I'm afraid I recently placed the near new original rear cargo cover on my daughters MX3.
Posted: December 26th, 2006, 12:30 am
by PATDIESEL
Evilyeti.com is where I was talking about that makes/sells a replacement hatch cover.
Posted: January 1st, 2007, 11:49 am
by markbrad
That looks nice
Posted: May 15th, 2007, 11:32 pm
by racer3v
That came out really nice. About how long did it take to complete?
Re: That looks nice
Posted: May 16th, 2007, 9:20 am
by magiccowinuse
racer3v wrote:That came out really nice. About how long did it take to complete?
Why do you keep bringing up old posts?