First 1/8th mile on new built bottom end
Posted: August 26th, 2006, 12:55 am
First time to the track with the new motor broke in good. I couldn't get the car to come out of the hole worth a crap...this time instead of frying tires it now bogs horribly with the heavy flywheel. I even tried leaving the line at 3000rpm and it STILL bogged! With the light weight flywheel on the low copression motor it used to FRY the tires. I wish I had the money for the Clutchnet 12lb flywheel and pressure plate...aswsome compromise between the 9lb or the 22lb ones I've used.
26psi and bogging bad out the hole...also blowing a hose every other run
Reaction 4.6115
60ft 2.649
330ft 6.726
1/8th trap 88.81 MPH
1/8th ET 9.57739
I was pissed....the car doesn't bog on the street with the 3-disc Car Chemistry silencer in the rear muffler but it chokes of a got bit of top end power. The car was a total animal on the back half! The heat from waiting to go through the pits was putting a toal on the car as well. My battery now has a buldge in it's side and the intake manifold was heating to over 140*F. Its time for me to build my heat shields and impliment my thermal efficiency game plan. Also going to install worm gear clamps on the rest of the hoses untill I can afford the AN fittings to utilze the SS-braided hose I have
26psi and bogging bad out the hole...also blowing a hose every other run
Reaction 4.6115
60ft 2.649
330ft 6.726
1/8th trap 88.81 MPH
1/8th ET 9.57739
I was pissed....the car doesn't bog on the street with the 3-disc Car Chemistry silencer in the rear muffler but it chokes of a got bit of top end power. The car was a total animal on the back half! The heat from waiting to go through the pits was putting a toal on the car as well. My battery now has a buldge in it's side and the intake manifold was heating to over 140*F. Its time for me to build my heat shields and impliment my thermal efficiency game plan. Also going to install worm gear clamps on the rest of the hoses untill I can afford the AN fittings to utilze the SS-braided hose I have