Page 1 of 1
Two coils or four on standalones??
Posted: August 7th, 2006, 2:28 pm
by cjthor
Hey guys...
Trying to figure out if I should run two of four with my microtech on my b6t hybrid. Pros and cons?
Posted: August 7th, 2006, 10:52 pm
by Josh
4 would be nice, but is it really needed. in my opinion Yes!!
i woul dgo with the 4, truth is you probably wont notice any differance
Posted: August 8th, 2006, 8:42 pm
by cjthor
for ease of wiring I think I am going to use two coils.
Posted: August 8th, 2006, 11:19 pm
by PATDIESEL
They say that 2 "good" coils will produce more than enough power for most any street driven car. The fact is that the plug and wire can only take so much voltage and thus they make the coils to exceed power for two plugs.
Also, on any other car ( not four banger) it is extremely hard to find a set-up with one coil per cylinder. Almost all use 2 per.
Posted: August 8th, 2006, 11:37 pm
by MechaManZero
I'm with PATDIESEL on this one cause 2 is def enough. 4 is overdoing it and a waste. It's another question of why do it and what are you gaining from it.
Posted: August 12th, 2006, 5:52 pm
by jschrauwen
My coilpack conversion with my megasquirt allows for a tripple coilpack. Each of which handles 2 cylinders which is more than sufficient.