Page 1 of 1
Wolf 3D ECU Question. Has any one used it or heard of it?
Posted: July 21st, 2006, 12:17 pm
by MechaManZero
Ok it is basically sucking right now cause my EMS keeps getting delayed so I am looking at getting a standalone. I was checking out Wolf 3D recently and looks like it is winning over the Haltek EMS in my opinion.
http://www.wolfems.com.au
Actually this place in Long Island NY has the base maps for 10 PSI as well. Like I said Wolf 3D is winning lol.
Posted: July 25th, 2006, 1:49 am
by MechaManZero
Are you telling me no one has heard of Wolf EMS.
website is
http://www.wolfems.com.au/
Posted: July 25th, 2006, 2:18 am
by Limegreen mx-3
I never even heard of them.
Posted: July 25th, 2006, 4:38 am
by BuGS
A lot of RX7 guys use it. rx7club.com is where you can find info...
Posted: July 25th, 2006, 10:16 am
by osargeant
I have heard of it but dont know of anyone using it. It is supposed to be out of Australia and very good, I see it being used on high end Skylines, RX7s, Supra etc.
There are a lot of very good standalone ECUs that come out of Australia and New Zealand.
Posted: July 25th, 2006, 10:41 am
by MechaManZero
I guess I will be the first on this site lol. Wish me good luck guys, well I should have it in like a couple weeks or so. But I found a place that tunes the Wolf 3D Version 4 over in Long Island, NY so hopefully I get some good results.
Posted: July 25th, 2006, 10:36 pm
by BuGS
best of luck man. The RX7's that have used it here in the PNW (pacific northwest) have all had sucess. A lot of the haltek guys (even my brother) have had problems with them grounding out and pretty much losing the tune and hurting the engine bigtime (My brother's $4,000 engine is blown up
)