MX-3.com

I post this here as well, since it fits this forum better than at the tail end of my slightly derailed (my doing... thank you, thank you) clearance post in appearance.

Jutzi420 wrote:

Bling Bling wrote:That's what I thought too but the question is how?

That's a good question, I can't really say until I try. I was thinking that these 90-91 CRX turn signals might be the most suitable.
http://www.eautoworks.com/html/ORD-1-1-1-22595.cfm

There's also a pretty big list of possible lenses here:
http://www.eautoworks.com/html/ast-Auto ... r~Lamp.htm

I would probably start by trying to make a bracket out of some scrap plastic or maybe some large metal corner braces and archor it to the bottom side ot the real bumper.

Also, if you don't care much how it looks even some all-round metal strapping and some self tapping screws could do wonders. Nobody would really notice behind the mesh anyway unless they got their face right up to it.

90-91 honda accord lenses fit..they have that sqared look...i fit them into mine....u will have to fiberglass rear brakets around the lenses to screw them on

I used crx turn signals.. fit like a glove