MX-3.com

Hi! Not sure if I'm in the appropiate forum, but here goes nothing.

I want to start a discussion about the windshield washer nozzles. I want to have those modern nozzles which spray the liquid evenly along the whole windshield instead of four sprays. I have thought of the new Mazda 6 and its nozzles. Do you guys think that these will fit, and will I have to upgrade anything else in the system (the motor, etc.)?

Thanks for your interest in this thread!

When I get home, I will look on my wifes 6 if I get a chance.

I assume they will, maybe with some small modification. But then again, I cant really tell you for sure unless I took a nozzle out. I dont think my wife would go for that

But I will try and check the size externally.

will I have to upgrade anything else in the system (the motor, etc.)?

The existing pump will drive them ok.

I was in my local Mazda store, and one nozzle cost $57 USD, so I will wait until my next paycheck to test-fit them.

Custommx3, did you have any luck looking at your wife's 6?